Smooth Fitness 9.35HR user manual Cleaning, Deck Lubrication

Page 31

www.smoothfitness.com

MAINTAINENCE

CLEANING:

Routine cleaning of your treadmill will extend the product's life.

31

•Warning: To prevent electrical shock, be sure the power to the treadmill is OFF and the power cord is unplugged from the wall electrical outlet before attempting any cleaning or maintenance.

•Important: DO NOT use abrasives or solvents to clean the treadmill. To prevent damage to the computer, keep liquids away and keep it out of direct sunlight.

•After each workout: Wipe off the console and other treadmill surfaces with a clean, water dampened soft cloth to remove excess perspiration.

•Weekly: Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts the belt and eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week.

DECK LUBRICATION:

The walking belt has been pre-lubricated at the factory. However, it is recommended that the running deck be checked periodically for lubrication to ensure optimal treadmill performance. Your treadmill should not have to be lubricated usually within the first 400 hours of use.

Every 2 months of operation lift the sides of the walking belt and feel the top surface of the running deck as far as you can reach. If you feel signs of silicone, no further lubrication is required. If it feels dry to the touch, follow the instructions below.

.To purchase lubricant Kit please contact Smooth Fitness 1-888-800-1167 To apply lubricant under the walking belt:

1.Position the walking belt so that the seam is located on top and in center of the walking board.

2.Insert the spray nozzle into the spray head of the lubricant can.

3.While lifting the side of the walking belt, position the spray nozzle between the walking belt and the board approximately 6" from the front of the treadmill and as far to the center as possible. Apply the silicone spray to the walking board, moving from the front of the treadmill to the rear. Repeat this on the other side of the belt. Spray approximately 1/4 bottle (supplied with treadmill) each time.

Allow the silicone to "set" for 1 minute before using the treadmill.

Spray lubricant from to back.

Page 30 Page 32
Image 31
Page 30 Page 32
Contents 35HR Motorized Treadmill For future service or related questions PrecautionsPower Requirements Power RequirementsOpen the boxes Before YOU BeginSupplied Components Supplied Hardware Complete Computer Console Complete Parts ListComplete Base Frame Components Complete Deck Frame Components 10 9.35HR Treadmill Most of the Parts Shown Here have Been PRE-ASSEMBLED Parts Diagram35HR Treadmill Parts Diagram Parts Diagram 517 501 602 604 601 832 809 605 603 822 818 Parts Diagram Unpacking and Inventory AssemblyAssemble Upright 307 308 402 403Assemble the Side Handlebars 804 805Assemble Front Handlebar 805Attaching the Upright Cover and Connect Computer Cable 806 807807 826 843 845 846 Attach Adjustable Cylinder to Treadmill FrameAssemble Front Plastic Shrouds Securing of the Upright Tubes Follow These Instructions to Level Your Treadmill Stabilizer Adjustment Features Motion Control Operation Maintainence HOW to Maintain the 9.35HR TreadmillDeck Lubrication CleaningLabor WarrantyBefore beginning Important StepsFinding your pulse Target Heart RateMuscle Groups Muscle ChartWarm up and cool down Stretching RoutineSymptom Resolution Troubleshooting888.800.1167
Top Page Image Contents