S T E P 1 ORANGE BAG
NOTE: During assembly, it is recommended to ensure that all bolts are in place and partially threaded before completely tightening any one bolt. During assembly steps 1 thru 4, do not completely tighten any bolts until completion of Step 4.
•Lay the rear floor support (AG2) flat on the ground, with pulley brackets on the top. Stand up seat support frame (AC1) and align holes along bottom of seat frame with end of rear floor support. Attach using two bolts (M10x70), four flat washers (10.2x22x2), and two nylon nuts (M10).
•Place the
10