S T E P 4 GREEN BAG
•The swing arm assembly is constructed by inserting the axle (D19) through the bracket (Z27), then adding a wavy washer (20.7x29.1x0.3), range of motion adjustment (AH1), spacer (20.7x26.5x4), and swing arm (AD1). See diagram for orientation. Slide the axle through the hole in the swing arm support (AC2). Attach a flat washer (12.5x50x2), lock washer (12.2x21.5x3), and bolt (M12x25). Make sure the flat near the axle head lines up with the flat in bracket Z27.
•Attach the leg pad (AD2) exercise arm to the lower part of swing arm by lining up the holes and inserting the axle (D20). Attach a lock washer (12.2x21.5x3), flat washer (13x26x2.5), and bolt (M12x25) to each end. Tighten. Make sure the end of the axle with the flat on it is inserted in the exercise arm, mating with the opening that has the flat in it.
•Insert the thigh pad support (AD3) into the remaining slot on the swing arm support and secure using bolt (M12x25), flat washer (26.5x50x2), lock washer (12.2x21.5x3). Make sure the pull pin is inserted in one of the location holes in plate during assembly.
•Tighten all hardware. When tightening weight stack tower bracket (Z27), make sure the axle (D19) is parallel to the floor.
13