S T E P 8 LIGHT BLUE BAG
J03
J02
AT3
AT4
AT2
AD1
J01
Z33
Z32
Z32
•Attach the seat post (AT2) to the seat frame by inserting four bolts (M10x45) and four flat washers (10.2x22x2) down through the top of the frame and fastening four more flat washers (10.2x22x2) and four nuts (M10).
•Attach the seatback bracket (AT4) to the seat post (AT3) with a bolt (M12x85) and a flat washer (13x26x2.5) and fastening another flat washer (13x26x2.5) and a nut (M12) to the opposite side. Don’t over tighten this joint.
•Take seat bottom (J02) and attach to seat post (AT3) using four bolts (M10x48). Secure seat back (J03) on seat back frame using two bolts (M10x25). Take seat assembly and insert into seat post support, making sure to disengage pull pin to allow insertion. After clicking seat post into a set position, slide a bolt (M8x62) with flat washer (8.4x15.5x1.6) through seat post support and secure with one nut (M8) on the other side.
•Slide the swing arm pad (J01) onto swing arm (AD1) and secure with round plastic stop (Z32), flat washer (8.4x15.5x1.6), and bolt (M8x15).
•Place round plastic stop (Z33) on each shaft of foot support base. Slide foot support pads onto shaft and secure using round plastic stop (Z32), flat washer (8.4x15.5x1.6), and bolt (M8x15) on each side.
AT1
18