S T E P 1 ORANGE BAG
NOTE: During assembly, it is recommended to ensure that all bolts are in place and partially threaded before completely tightening any one bolt. During assembly steps 1 thru 4, do not completely tighten any bolts until completion of Step 4.
•Lay the center floor support (AG2) flat on the ground. Hold the main seat support (AC1) upright and align the holes near the pulley bracket with the holes on the center floor support. Make sure the pulley bracket on center floor support is on the opposite side of the attachment. Secure connection with two bolts (M10x120 & M10x25), three flat washers (10.2x22x2), and a nylon nut (M10).
AG2
AC1
10