JVC MX-GA8 manual Using Recording Timer

Page 27

6 Select the preset station number.

Turn the 4/¢ control to select the preset station number, then press SET. The unit enters volume setting mode.

SET

7 Turn the 4/¢ control to set the volume level.

• You can select the volume level from VOL MIN, VOL 1 — VOL 30, and VOL MAX.

WOOFER

8 Press SET to complete the Daily

SET

Timer setting.

 

The DAILY (daily timer) indicator stops

flashing and remains lit. The settings you have done are shown on the display in sequence for your confirmation.

9 Press

STANDBY/ON to turn

STANDBY

 

 

STANDBY/ON

off the unit (on standby) if you

 

have set the Daily Timer with the

 

unit turned on.

 

If the unit is turned on when the timer-on time comes

Daily Timer does not work.

To turn on or off Daily Timer after its setting is done

1

Press CLOCK/TIMER repeatedly

CLOCK

 

 

until “DAILY” appears on the display.

 

/ TIMER

 

2

 

 

 

 

 

 

To turn off the Daily Timer, press

 

 

 

 

CANCEL

 

 

 

 

 

CANCEL/DEMO.

 

 

 

/ DEMO

 

 

 

 

 

 

 

 

 

 

 

 

The DAILY (daily timer) indicator goes off from the display (“OFF” appears for a while).

The Daily Timer is canceled, but the setting for the Daily Timer remains in memory until you change it.

To turn on the Daily Timer, press SET.

SET

The DAILY (daily timer) indicator lights up on the display. The settings you have done are shown on the display in sequence for your confirmation.

Continued

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically. You can set the timer whether the unit is on or off.

How Recording Timer actually works

The unit automatically turns on, tunes in to the specified station, sets the volume level to “VOL MIN,” and starts recording when the on-time comes (the indicator flashes while the timer is operating). Then, when the off-time comes, the unit automatically turns off (stands by).

Recording Timer works only once, but the timer setting remains in memory until you change it.

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

If you have made a mistake while setting the timer, press CANCEL/DEMO. (However, this does not always work. If CANCEL/DEMO does not work, press CLOCK/TIMER repeatedly and start from step 2 again.)

On the unit ONLY:

1 Put a recordable cassette into deck B.

2 Press CLOCK/TIMER

 

 

/ TIMER

 

 

CLOCK

repeatedly until “REC”

 

 

 

 

 

 

appears on the display.

 

indicator lights up and the REC (recording timer) indicator starts flashing on the display.

WOOFER

Each time you press the button, the clock/timer setting modes change as follows:

DAILY

 

 

ON TIME

 

 

REC

 

 

 

 

 

 

 

(Daily Timer)

 

 

 

Canceled

 

 

CLOCK

 

 

ON TIME

 

 

 

 

(See page 9.) (Recording Timer)

3 Press CLOCK/TIMER again.

 

 

/ TIMER

 

 

CLOCK

“ON TIME” appears for 2 seconds, then

 

 

 

 

 

 

the unit enters on-time setting mode.

WOOFER

English

24

Image 27 Contents
Instructions Avisos, precauciones y otras notas Important for Laser Products Importante Para Productos Láser Precautions IntroductionAbout This Manual Contents Front Panel Location of the Buttons and ControlsFront Panel Display WindowRemote Control Remote ControlFM antenna Connecting AntennasGetting Started UnpackingTo connect an outdoor AM antenna Connecting SpeakersRelease the finger from the clamp AM antennaTo connect audio equipment Connecting Other EquipmentCanceling the Display Demonstration On the unit onlySelecting the Sources Turning On or Off the PowerSetting the Clock Common OperationsEnjoying the Heavy Sound Adjusting the VolumeTo turn down the volume level temporarily Reinforcing the Bass SoundOn the unit On the remote controlSelecting the Sound Modes Turning On or Off the Key-touch ToneListening to the Radio Tuning in to a Station-Auto SearchTuning in to a Preset Station Presetting StationsPlaying Back CDs Loading CDsPlaying Back CDs-All Disc and One Disc CD playback sequence When the MP3 playback mode is the Track mode See alsoTo stop during play, press To remove the disc, pressBasic CD Operations 1 Disc indicator lights up on DisplayTo go to another album on an MP3 disc To go to another track directly using the number buttonsFor MP3 disc When the MP3 playback mode is the Track mode When the MP3 playback mode is the Album modeChanging the MP3 Playback Mode On the remote control onlyTurning On or Off the Resume Play for MP3 Disc Program other tracks you want Programming the Playing Order of the Tracks --Program PlayPress Program so that Program appears on DisplayRandom appears on Display Playing at Random--Random PlayRepeating Tracks or CDs--Repeat Play Prohibiting Disc Ejection--Carrousel LockClose the cassette holder gently Playing Back TapesPlaying Back a Tape Press 0EJECT for the deck you want to useTo protect your recording RecordingRecording a Tape on Deck B Press REC START/STOPNumber buttons CD1 CD2, and CD3 to select Disc, then Dubbing TapesCD Synchronized Recording On the unit only Press Tape 3, thenUsing Daily Timer Using the TimersUsing Recording Timer Timer Priority Using Sleep TimerHandling cassette tapes MaintenanceCleaning the unit Handling discsSymptom TroubleshootingSpecifications EN, SP JVC 0503TMMMDWSAM