Star Trac E-TRXE, E-TRE manual Error Name Description Diagnosis Code

ERROR	NAME	DESCRIPTION		DIAGNOSIS
CODE
39	Speed calibra-	Fit CPU reports MCB error	1.	Re-boot the unit and see if the problem goes away.
	tion value out of	status: Speed calibration	2.	If the problem persists, check the Product Model in
	range	value out of range
				Maintenance Mode and ensure it is correct.
			3.	Re-calibrate the Speed.
40	Speed lost	Fit CPU reports MCB error	1.	Re-boot the unit and see if the problem goes away.
	(RPM Sensor)	status: Speed lost (RPM	2.	If the problem persists, check the Product Model in
		Sensor)
				Maintenance Mode and ensure it is correct.
			3.	Re-calibrate the Speed.
			4.	If the problem persists check the speed sensor. Ro-
				tate the flywheel on the motor and ensure that the
				speed sensor LED on the MCB blinks as the flywheel
				is moving.
41	Incline feedback	Fit CPU reports MCB error	1.	Re-boot the unit and see if the problem goes away.
	out of range	status: Incline feedback out	2.	If the problem persists, check the Product Model in
		of range		Maintenance Mode and ensure it is correct.
			3.	Re-calibrate the Incline.
			4.	If the problem persists, check to see that the Incline
				Counts value in the Incline Calibration Screen is
				changing during incline calibration. The Incline Counts
				should go down as the elevation goes up.
			5.	If the Incline Counts is not changing during calibration,
				then the cable from the elevation motor to the MCB
				should be checked. If the cable is OK then the eleva-
				tion motor should be replaced.
42	Incline stuck	Fit CPU reports MCB error	1.	Re-boot the unit and see if the problem goes away.
		status: Incline stuck	2.	If the problem persists, check the Product Model in
				Maintenance Mode and ensure it is correct.
			3.	Re-calibrate the Incline.
			4.	If the problem persists, check to see that the Incline
				Counts value in the Incline Calibration Screen is
				changing during incline calibration. The Incline Counts
				should go down as the elevation goes up.
			5.	If the Incline Counts is not changing during calibration,
				then the cable from the elevation motor to the MCB
				should be checked. If the cable is OK then the eleva-
				tion motor should be replaced.
255	emergency stop	Fit CPU detected emer-	1.	Reset the E-Stop switch and the product will become
	condition	gency stop condition		operational again.
			2.	If the problem persists, check the cables/connections
				in the Hot Bar. Also check the e-stop cable from the
				Hot Bar that plugs into the FitCPU.
			3.	If the problem still persists check the communications
				cable between the FitCPU and the Translator Board.
			4.	If all of the above is OK then replace the Translator
				Board.

40