Image IMTL30510.0 warranty Knob Spring Collar Large Hole Pin

Page 12

12.See the lower drawing. Position the Uprights (53, 54) so that the Frame (51) is centered be- tween them.

Firmly tighten the two M10 x 60mm Patch Bolts

(1) and the four M10 x 58mm Bolts (2) (only one side is shown). Be careful not to overtighten the M10 x 60mm Patch Bolts.

Raise the Uprights (53, 54).

13.Attach the Latch Housing (48) to the Left Upright (53) with two #10 x 1" Tek Screws (13); start both Tek Screws, and then tighten each of them. Make sure that the large hole in the Latch Housing is on the indicated side. Locate the Latch Pin Assembly (24). Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two collars, place one on each side of the spring.) Insert the pin into the Latch Housing (48). Then, tighten the knob onto the pin.

12		53, 54	1
		53, 54	2
			2
		51
		Top View
54		51	53
13
Knob 24	48	53
Knob 24	48

13	Spring
13	Collar
Large Hole	Pin

14.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys in a secure place. One of the hex keys is used to adjust the walking belt (see page 21). To protect the floor or carpet, place a mat under the treadmill.

12

Image 12

Contents QUESTIONS? Model No. IMTL30510.0 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Page Before YOU Begin For your benefit, read this manual carefully beforeAssembly Make sure that the power cord is unplugged Overtighten the Nuts the Wheels should turn FreelyHold the Left Upright 53 so that the small Holes are positioned as shown. Attach the LeftBolt yet Top ViewConsole Tie Wire Bracket Large Hole Small Wire Tie 103 Console Console Wire Tie Into the Uprights. Then, firmly tighten all four Bolts Knob Spring Collar Large Hole Pin Operation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeInsert the key into the console Start the walking beltMeasure your heart rate if desired. Before using Follow your progress with the displays. The lower leftHOW to USE a Preset Workout Start the workoutInformation Mode HOW to Fold and Move the Treadmill HOW to Fold the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USETroubleshooting Problem The power turns off during useCompatible with GFCI-equipped outlets Problem The walking belt slows when walked on Walking belt. If the walking belt has shifted toExercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. IMTL30510.0 Key No. Qty DescriptionR0910A Exploded Drawing B-Model No. IMTL30510.0 Exploded Drawing C-Model No. IMTL30510.0 Exploded Drawing D-Model No. IMTL30510.0 Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT