Image IMTL30510.0 warranty Make sure that the power cord is unplugged, Same way

1.	Make sure that the power cord is unplugged.	1		26
	Position the Base (52) upside-down as shown.	26
				63
	Attach four Base Feet (63) to the Base (52) with		63			52
	four M4.2 x 19mm Tek Screws (26).
						6326
				26
				63
2. Attach the Wheels (70) to the Base (52) with two		2
	M10 x 60mm Bolts (35), four Wheel Spacers					52
	(69), and two M10 Nuts (16) as shown. Do not	35
	overtighten the Nuts; the Wheels should turn
	freely.			16
		69 70	69
				16		35
				69 70	69
3. Have a second person hold the Base (52) in the		3
	position shown.
	Identify the Left Upright (53) (the Right Upright
	[54] has a square hole near the lower end).
	Hold the Left Upright (53) so that the small		Small			54
	holes are positioned as shown. Attach the Left
	Upright (53) to the Base (52) with two M10 x		Holes
	58mm Bolts (2) and two M10 Star Washers (9);		53	Square		2
	do not fully tighten the Bolts yet.
	Attach the Right Upright (54) to the Base (52)			Hole		9
				9
	in the same way.
					2	52
		7