Keys Fitness KF-T4-0 owner manual Step

Page 9

www.keysfitness.com

4

SCREW ST4.2*13

6MM

TOOL

ASSEMBLY FOR FENDERS

Step 1:

Lift up the base of the treadmill until the pop pin located on the left side engages.

Step 2:

On the outer part of the fenders, secure the right and left fenders with 2 phillips screws M6*30 and 2 flat washers M6*12*1.6 mm.

		Step 3:
		On the inner part of the fender secure the
		right and left fenders with 2 phillips screws
		M620 and 2 flat washers M612*1.6.
	WASHER 6.6* 12*1.6mm
		ASSEMBLY FOR END CAPS
	PHILLIPS SCREW M6*20	In the treadmill’s folded position, secure
		the end caps with screws ST 4.2*13 (Qty
	PHILLIPS SCREW M6*30	4).
	PHILLIPS SCREW M6*30	Assembly 9
		Assembly 9

Image 9

Contents Keys Fitness Products KF-T4.0Table of Contents Safety Information Safety Precautions and TipsAssembly Parts Identifier Assembly for Upright Tubes Assembly Step Assembly for END Caps Assembly for FendersAssembly for Console Step Congratulations Moving Instructions Moving InstructionsPower Requirements Power RequirementsConsole Information Console Information Console FunctionsProgram Mode Quick Start / Manual Mode P1Incline + Speed +Time Goal P2 Cool DownDistance Goal P3 Calories Goal P4Programs P7 P13 5K RUN and 10K RUN P5 P6Frequency, Intensity, Time, Target Heart Rate Zone Cool Down WorkoutCool down Slow and Relaxed Exercise Target Heart Rate Zone Workout Information Cat and Camel Prone on ElbowsKnees to Chest Shoulder CirclesWrist Flexor Wrist ExtensorOne-Arm Pectoralis Stretch Groin Adductors StretchStanding Quadriceps Stretch Calf StretchTroubleshooting Calibrating Treadmill Safety Interlock Error Messages Treadmill Error MessagesOther Error Messages Error codeBelt Adjustment Walking Belt is Slipping During USE DiagramBelt Adjustment Maintenance Instruction Maintenance InstructionsTreadmill will not start Troubleshooting GuideParts Information View Fitness.comDescription Qty Exploded View / Parts ListResidential and Personal Use Limited Warranty Warranty Information