HOW to USE a Custom Program

Current Period Column

the first period will be shown

in the flashing Current Period column of the program dis- play. (The in- cline settings are not shown

in the program

display.) To program the desired speed and in- cline settings for the first period, simply adjust the speed and incline of the treadmill to the desired levels with the Speed and Incline buttons. Every few times one of the Speed buttons is pressed, an additional indicator will light or darken in the Current Segment column. Note: Indicators will light or darken in the columns to the right of the Current Segment column as well; disregard these columns.

When the first period of the program is completed, the current speed setting and the current incline setting will be stored in memory. All columns in the program display will then move one column to the left, and the speed setting for the second pe- riod will be shown in the flashing Current Period column. Program speed and incline settings for the second period as described above.

Repeat this procedure until you have programmed speed and incline settings for as many periods as desired—custom programs can have from one to forty periods. When you are finished, press the Stop button, remove the key from the console, and then reinsert the key. The speed and incline set- tings you programmed and the number of periods will be stored in memory.

To stop the program temporarily, press the Stop button. All displays will pause and the Time/ Segment Time display will begin to flash. To restart the program, press the Start button.

6 Follow your progress with the five displays.

Refer to step 6 on page 11.

7 Remove the key from the console.

When the program has ended, make sure that the incline of the treadmill is at 0%. Next, re- move the key from the console. Keep the key in a secure place. Note: If the displays and indica- tors on the console remain lit after the key is removed, the console is in the “demo” mode. Refer to page 23 and turn off the demo mode.

Next, move the on/off switch near the power cord to the off position.

1 Insert the key into the console.

See HOW TO TURN ON THE POWER on page 10.

2 Select one of the custom programs.

When the key is in- serted, the manual mode will be se- lected and the man-

ual indicator will light. To select one of the

custom programs, press the Program Select but- ton repeatedly until one of the two custom pro- gram indicators lights.

When a custom pro- gram is selected, a “C1” or “C2” will ap- pear in the program display.

3 Put on the heart rate monitor if desired.

For the Pulse display to show your heart rate, the heart rate monitor must be worn. To put on the heart rate monitor, see HOW TO USE THE HEART RATE MONITOR on page 6.

4 Press the Start button.

A moment after the button is pressed, the walking belt will begin to move. Hold the handrails and begin walking.

Each custom program is di-

vided into one- minute periods. One speed set- ting and one in- cline setting are programmed for each period. The speed set-

ting for the first period will be shown in the flash- ing Current Period column of the program display. (The incline settings are not shown in the program display.) The speed settings for the next seven- teen periods will be shown in the seventeen columns to the right.