HOW TO USE PROGRAMS DIRECTLY FROM OUR INTERNET SITE
Our Web site at www.iFIT.com allows you to access basic programs, audio programs, and video programs directly from the internet. Additional options, such as
To use programs from our internet site, the treadmill must be connected to your home computer. See HOW TO CONNECT YOUR COMPUTER on page 16. In addition, you must have an internet connection and an internet service provider. A list of specific system requirements will be found on our internet site.
Follow the steps below to use a program from our internet site.
1 Insert the key into the console.
See HOW TO TURN ON THE POWER on page 10.
2 Select the iFIT.com mode.
When the key is in- serted, the manual
mode will be selected
and the manual indi- cator will light. To use
a program from our
internet site, press the Program Select button re- peatedly until the iFIT.com indicator lights.
3 Go to your computer and start an internet connection.
4 Start your web browser, if necessary, and go to our internet site at www.iFIT.com.
5 Follow the desired links on our internet site to select a program.
Read and follow the
6 Follow the on-line instructions to start the program.
When you start the program, an
7 Return to the treadmill and stand on the foot rails. Find the clip attached to the key and slide the clip onto the waistband of your clothes.
When the
During the program, an electronic “chirping” sound will alert you when the speed and/or incline of the treadmill is about to change. CAUTION: Always listen for the “chirp” and be prepared for speed and/or incline changes.
If the speed or incline settings are too high or too low, you can manually override the settings at any time by pressing the Speed or Incline buttons on the console. However, when the next “chirp” is heard, the speed and/or incline will change to the next settings of the program.
To stop the walking belt at any time, press the Stop button on the console. The Time/Segment Time display will begin to flash. To restart the pro- gram, press the Start button. After a moment, the walking belt will begin to move at 1.0 mph. When the next “chirp” is heard, the speed and incline will change to the next settings of the program.
When the program is completed, the walking belt will stop and the Time/Segment Time display will begin to flash. Note: To use another program, press the Stop button and go to step 5.
Note: If the speed or incline of the treadmill does not change when a “chirp” is heard, make sure that the iFIT.com indicator is lit and that the Time/Segment Time display is not flashing. In addition, make sure that the audio cable is properly connected, that it is fully plugged in, and that it is not wrapped around a power cord.
8 Follow your progress with the five displays.
See step 7 on page 11.
9 Whenkey. the program is completed, remove the
Refer to step 6 on page 12.
19