5.See step 1. Hold the Right Upright (95) while another per- son holds the Left Upright (90). Remove the two Upright Bolts (86) used in step 1.
Slide the Right Upright (95) and the Left Upright (90) fully onto the brackets on the Base (99) at the same time. Be careful to avoid pinching your hands or the Wire Harnesses (not shown).
Attach the Right Upright (95) with four Upright Bolts (86) and two 3/8” Star Washers (88) as shown. If necessary, adjust the position of the Right Upright to align the Upright Bolts with the holes. Attach the Left Upright (90) in the same way. Note: There are no wires on the left side.
Firmly tighten all sixteen Upright Bolts (86) used in steps 3 and 5.
5 | 90 |
| |
| 95 |
| 88 |
| 86 |
| 86 |
| 99 |
6.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the walking belt (see page 29). To protect the floor or carpet, place a mat under the treadmill.
If you purchase the optional chest pulse sensor (see page 25), follow the steps below to install the re- ceiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated Screw (83) and the Access Door (117) from the underside of the Console Back (85) on the left side.
2.Connect the wire on the receiver (A) to the indicated wire extending from the Console Back (85). Hold the re- ceiver so the small cylinder is oriented as shown. Attach the receiver to the plastic posts on the Access Door (117) with the two included small screws.
3.Make sure that no wires are pinched. Reattach the Access Door (117) with the Screw (83). The other wires included with the receiver may be discarded.
| 85 |
Small |
|
Screws | Small |
| |
| Cylinder |
A |
|
Wire |
|
117 | 83 |
|
8