5.While a second person holds the console assembly near the Handrail (20) as shown, attach the ground wire to the indicated hole in the Handrail with a Silver Ground Screw (94).
6.While a second person continues to hold the console as- sembly, look underneath it and locate the Console Wire Harness (78).
Connect the Console Wire Harness (78) to the Upright Wire Harness (77). Make sure to connect the connec- tors properly (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and then try again. IF THE
CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, insert the Wire Harnesses down into the Handrail (20).
7.Set the console assembly on the Handrail (20). Be care- ful to avoid pinching any of the wires. Hand tighten five Screws (3) into the Handrail and the console assem- bly. Do not put Screws into the two indicated holes.
Start all five Screws, but do not tighten them yet.
5 |
Ground |
Wire |
94 |
Hole |
20 |
Console |
Assembly |
6 |
78 |
Console |
Assembly |
77 |
78 |
77 |
20 |
7 | Console Assembly |
| |
20 |
|
3 | 3 |
3 | |
| No Screws |
8