7.Tighten two 3” Bolts (98) with two Washers (97) into the bottom of the Upright Base (96) and the Handrails (67) (only one Handrail is shown). Firmly tighten the Bolts.
With the help of a second person, carefully tip the Upright Base (96) so it is flat on the floor. Remove the cardboard from underneath the Upright Base.
8.Fold the Incline Trainer to the storage position (see HOW TO FOLD THE INCLINE TRAINER FOR STORAGE on page 28).
Slide the Right Wheel Bracket (59) into the slot in the Right Rear Endcap (57). Align the holes in the Bracket with the holes in the Frame (43). Attach the Bracket to the Frame with two 1” Bolts (55).
Attach the Left Wheel Bracket (not shown) in the same way.
7 |
|
| 98 |
| 97 |
| 96 |
67 | 98 |
| |
| 97 |
8 |
|
| 57 |
| 59 |
| 43 |
| 55 |
9.Make sure that all parts are properly tightened before you use the Incline Trainer. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 31). To protect the floor or carpet from damage, place a mat under the Incline Trainer.
9