NordicTrack NTL2495.2 user manual Washers 114. Firmly tighten the four Console Bolts, This step

2. Have a second person hold the console assembly near	2
the Upright (111). Insert the cable and the wire harness
extending from the console assembly through the hole in
the top of the Upright. Attach the console assembly to the
Upright with four Console Bolts (110) and two Star
Washers (114). Firmly tighten the four Console Bolts.
Next, connect the cable and the wire harness extending				108
from the console assembly to the TV Cable (109) and the
Wire Harness (108). The connectors should slide to-
gether easily and snap into place. If they do not, turn				Console
one connector and try again.			109
				Assembly
			114	114
				110
			110
			111	108
3. Note: For clarity, the console assembly is not shown	3	Cutouts
in this step.
				112
Orient the Short Panel (106) so that the indicated cutouts
in the top of the Panel are at the top. Have a second per-				139
son hold the Short Panel against the Upright (111), with	140		108
the top of the Short Panel flush with the top of the
Upright. Firmly tighten the four Upright Bolts (113).		109
Route the TV Cable (109) down one side of the Short
Panel, and route the Wire Harness (108) down the other
side of the Short Panel, as shown.
Next, hold the Long Panel (112) against the opposite side			140	139
of the Upright (111); make sure that the top of the Long		106
Panel is flush with the top of the Upright and that no	111
wires are pinched. Press the Long Panel and the Short
Panel (106) together, and align the three holes in the
Long Panel with the holes in the three Panel Brackets
(140). Attach the Long Panel and the Short Panel with				139
three Panel Screws (139).
			140
				113

8