NordicTrack NTL07707.0 Tor and try again. if the Connectors are, Not Connected PROPERLY, the CON

7. Set the console assembly face down on a soft	7
surface to avoid scratching the console assem-
bly. Hold the Right Handrail (95) near the con-
sole assembly. Next, insert the console wire into			Console
the large hole in the Right Handrail and out of
			Wire
the top as shown. If necessary, use needlenose
pliers to help pull the console wire out.	95	1	Hole
Attach the Right Handrail (95) and the Left				1
Handrail (not shown) with four #8 x 3/4" Screws
(1) (two are shown). Make sure that no wires
are pinched. Start all four Screws before
tightening any of them; do not overtighten
the Screws.
				Console
				Assembly
8. Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star	8
Washer (33) into the bracket and Handrail
Crossbar (94) on each side of the console as-			5	Wire
sembly (only one side is shown).
				Tie
			33
Remove the wire tie from the console wire.
	Console
	Assembly		94
9. Remove the long tie from the Upright Wire (38).	9
Have a second person hold the console assem-		Console
		Assembly
bly near the Right Upright (78) and Left Upright
(not shown). Connect the Upright Wire (38) to
the console wire. See the inset drawing. The
connectors should slide together easily and
snap into place. If they do not, turn one connec-
tor and try again. IF THE CONNECTORS ARE	Console
NOT CONNECTED PROPERLY, THE CON-
	Wire
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Attach the console assembly to the Right Upright		78		Console
(78) and Left Upright (not shown) with four 5/16"		38	Long	Wire
x 3 1/4" Bolts (7) and four 5/16" Star Washers			Tie
(10) (only two are shown). Be careful not to		10
pinch the wires.
				38
	7
See steps 4 and 6. Tighten the four 3/8” x 5”
Bolts (6).
	9