NordicTrack NTL07707.0 user manual

Page 24

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt is off-center, first remove the key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the hex key to turn the left rear roller bolt clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the bolt counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walk- ing belt is centered.

a

b. If the walking belt slips when walked on, first re- move the key and UNPLUG THE POWER CORD. Using the hex key, turn both rear roller bolts clock- wise, 1/4 of a turn. When the walking belt is cor- rectly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walk- ing belt centered. Then, plug in the power cord, in- sert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

b

24

Image 24

Contents QUESTIONS? Please do not ContactCall TOLL-FREE On the WEBTable of Contents Important Precautions Page Before YOU Begin Assembly Make sure that the power cord is unplugged See the inset drawing. Tie the long tieBe careful not to pinch the Upright Wire Them several times do not fully tighten Bolts yetNot fully fold the Frame yet Nut the Wheel must turn freely. DiscardTor and try again. if the Connectors are Sole MAY be Damaged When Power is Turned onPinch the wires Not Connected PROPERLY, the CONPage Page Operation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Insert the key into the consoleChange the incline of the treadmill as desired When you are finished exercising, remove Adjust the incline of the treadmill to the lowestKey from the console It to the storage position. Next, remove the keyHOW to USE a Preset Workout Select one of the preset workoutsHOW to USE AN Ifit Card Select a display mode and monitor yourInsert an iFIT card and select a workout Progress with the displayHOW to USE the Stereo Sound System Information ModeHOW to Adjust the Cushioning System HOW to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Move the Treadmill HOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useProblem The walking belt slows when walked on Page Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyR0907C Key No. Qty DescriptionQty Exploded Drawing A-Model No. NTL07707.0 Exploded Drawing B-Model No. NTL07707.0 Exploded Drawing C-Model No. NTL07707.0 Exploded Drawing D-Model No. NTL07707.0 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT