HOW to USE a Preset Workout

1.Insert the key into the console.

See HOW TO TURN ON THE POWER on page 14.

2.Select one of the preset workouts.

To select a

weight loss workout or a

performance

workout, press the Weight Loss

Workouts button or the Performance Workouts but- ton. Profiles of the speed settings of the workouts will appear in the display. To select an aerboic workout, press the Weight Loss Workouts button and then press the down Navigation button until the aerobic profiles appear in the display. Use the Navigation buttons to highlight the desired profile. The maximum speed setting and maximum incline setting of the workout will be shown. Press Enter to select the workout.

As each preset workout is se- lected, the max- imum speed

setting of the workout and the

maximum incline setting of the workout will flash in the displays for a few seconds. The workout time and a profile of the speed settings of the workout will appear in the display.

3.Press the Start button or the Speed increase button to start the workout.

A moment after you press the button, the treadmill will automatically adjust to the first speed and in- cline settings for the workout. Hold the handrails and begin walking.

Each workout is divided into one-minute segments. One speed setting and one incline setting are pro- grammed for each segment. Note: The same speed and/or incline setting may be programmed for con- secutive segments.

A profile of the speed settings of the workout will appear in the dis- play. A small arrow below the

profile will indicate your progress.

At the end of the first one-minute segment of the workout, a series of tones will sound. If a different speed setting and/or incline setting is programmed for the second segment, the speed setting and/or incline setting will flash in the display for a moment to alert you. The treadmill will then automatically adjust to the speed and incline settings for the sec- ond segment.

The workout will continue in this way until the small arrow reaches the right end of the profile. The walking belt will then slow to a stop.

If the speed or incline setting is too high or too low at any time during the workout, you can override the setting by pressing the Speed or Incline but- tons; however, when the next segment begins, the treadmill will automatically adjust to the speed and incline settings for the next segment.

To stop the workout at any time, press the Stop button. To restart the workout, press the Start but- ton. The walking belt will begin to move at 1 mph. When the next segment of the workout begins, the treadmill will automatically adjust to the speed and incline settings for the next segment.

4.Select a display mode and monitor your progress with the display.

See step 5 on page 15.

5.Measure your heart rate if desired. See step 6 on page 16.

6.Turn on the fan if desired. See step 7 on page 16.

7.When you are finished exercising, remove the key from the console.

See step 8 on page 16.