S E M B LY Step | Horizon Fitness T50, T70 manual

INTRODUCTION

PRE - ASSEMBLY

A S S E M B LY STEP 2

INTRODUCTION

IMPORTANT PRECAUTIONS

ASSEMBLY

DO NOT CUT STRAPS UNTIL STEP 1.4!* Disassemble box and remove the WARNING cardboard packaging that is not beneath the treadmill. Do not attempt to lift the treadmill at this time. Reach under treadmill running deck to locate parts box.

Remove plastic wrap from console masts.

NOTE: It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before completely tightening any ONE bolt.

A S S E M B LY STEP 1

��

AWith running deck in lowered position, place CONSOLE on upright masts. Slide the brackets that are underneath the console handlebars into the top holes of the upright masts.

BPlace BOLT (?) into outside of LEFT upright MAST and tighten with NUT (?).

CRepeat on Right Side.

D Place 2 BOLTS (?) into inside of

LEFT upright MAST and tighten.

IMPORTANT PRECAUTIONS

ASSEMBLY

A Lift LEFT CONSOLE MAST into

upright position. Be sure to hold

* Be sure to tighten bolts after all are lined up.

ERepeat on Right Side.

BEFORE YOU BEGIN

��

the console mast firmly, as it

will not stay in the upright

position on it’s own.

A S S E M B LY STEP 3

BEFORE YOU BEGIN

TREADMILL CONDITIONING TROUBLESHOOTING OPERATION GUIDELINES & MAINTENANCE

��

*NOTE: If the straps have been removed before completing STEP 1, refer to the TROUBLESHOOTING section (page 26) in order to restore the treadmill to its proper position.

BMove LEFT SIDE LINKAGE ARM into position. Insert TEFLON WASHER (B) (2 pcs) and BOLT

(A) and tighten.

CRepeat on the right side.

DNow cut the banding straps and remove remaining packaging material.*

ASSEMBLED IN STEP 3

AGently lift RIGHT side of the console to connect the CONSOLE CABLE. Carefully tuck wires in mast to avoid damage. NOTE: Do not pinch console cable or grip pulse wires.

BRepeat steps 2-3 above to assemble the right side upright mast and console.

CConnect power plug to the treadmill and connect the cord to a power outlet. The on/off switch is located next to the power cord. Flip this switch to the 'on' position, so that the switch is lit. You will hear a beep and the console will light up.

TREADMILL OPERATION

TROUBLESHOOTING CONDITIONING & MAINTENANCE GUIDELINES

LIMITED

WARRANTY

YOU’RE FINISHED!

LIMITED WARRANTY

T50-T70_Treadmill.indd 8-9

4/21/05 9:03:47 AM