Horizon Fitness 1.2T, 5.2T, 2.2T, 3.2T, 4.2T Treadmill Operation, 2T, 2 T Console Features & Display

Page 9

INTRODUCTION

TURN POWER ON

Make sure that your treadmill is properly connected to a power outlet. The on/off switch is located next to the power cord. Flip this switch to the 'on' position, so that the switch is lit. You will hear a beep and the console will light up.

TREADMILL OPERATION

1 . 2T, 2 . 2T CONSOLE FEATURES & DISPLAY

QUICK START UP

INTRODUCTION

IMPORTANT PRECAUTIONS

TENSIONING THE RUNNING BELT

The running belt has been properly adjusted at the factory before it was shipped. At times the belt can move off-center during shipment.

Simply press the START button to begin exercising.

IMPORTANT PRECAUTIONS

ASSEMBLY

CAUTION: Running belt should NOT be moving during tensioning. Over-tightening the running belt can cause excessive wear on the treadmill as well as its components. Never over-tighten the belt.

PAUSE

1.2T

2.2T

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

If you can feel a slipping sensation when running on the treadmill, the running belt must be tightened. In most cases, the belt has stretched from use, causing the belt to slip. This is a normal and common adjustment. To eliminate this slipping, turn the treadmill off and tension BOTH THE REAR ROLLER BOLTS using the supplied Allen wrench, turning them 1/4 TURN to the right as shown. Turn the treadmill on and check for slipping. Repeat if necessary, but NEVER TURN the roller bolts more than 1/4 turn at a time. Belt is properly tensioned when the slipping sensation is gone.

CENTERING THE RUNNING BELT

The running belt has been properly adjusted at the factory before it was shipped. At times the belt can move off-center during shipment. Before operating the treadmill, make sure the belt is centered and remains centered to maintain smooth operation.

Press the STOP button to pause your workout.

RESET

Press and hold the STOP button to reset the treadmill.

ONE TOUCH™ SPEED KEYS

2.2T also has One Touch™ Incline Keys

BEFORE YOU BEGIN

TREADMILL OPERATION

CONDITIONING TROUBLESHOOTING LIMITED

GUIDELINES & MAINTENANCE WARRANTY

16

Belt is too far to the left side

CAUTION: Do not run belt faster than 1/2 mph while centering. Keep fingers, hair and clothing away from belt at all times.

If the running belt is too far to the right side:

With the treadmill running at 1/2 mph, turn the right adjustment bolt clockwise 1/4 TURN at a time (using the supplied Allen wrench). Check the belt alignment. Allow belt to run a full cycle to gauge if more adjustment is needed. Repeat if necessary, until the belt remains centered during use.

If the running belt is too far to the left side:

With the treadmill running at 1/2 mph, turn the right adjustment bolt counter-clockwise 1/4 TURN at a time (using the supplied Allen wrench). Check the belt alignment. Allow belt to run a full cycle to gauge if more adjustment is needed. Repeat if necessary, until the belt remains centered during use.

When in a program, the user is able to press any of the desired ONE TOUCH™ KEYS to get to a specific speed more quickly. NOTE: When in a speed-based program, if the user presses any of the ONE TOUCH™ SPEED KEYS, all of the remaining speed segments in the program will be modified as well. For example, when in P2, the first segment default speed is 2.5 mph. If the user presses the 4 mph ONE TOUCH™ SPEED KEY, all of the remaining segments will increase by 1.5 mph as well.

CHANGING THE SPEED AND INCLINE

When in a program, the user is able to change the difficulty of the program by pressing the or buttons to the desired level. NOTE: The user is only able to increase or decrease the incline or speed during the program. When in a program, if the user increases or decreases the difficulty of speed or incline, all of the remaining program speeds or incline segments will be modified as well. For example, when in P2, the first segment default speed is 2.5 mph. If the user increases the speed, all of the remaining segments will be increased by 1 mph as well.

17

LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES

Elite 1.2T-5.2T Rev 1.4.indd 16-17

8/2/05 2:47:34 PM

Image 9
Contents Treadmill USER’S Guide T R O D U C T I O N Table of ContentsOther Safety Tips for Your Treadmill Important PrecautionsGrounding Instructions OperationUnpacking Warranty RegistrationEnter Your Serial Number Model Name in the Boxes below Serial Number Model NamePRE Assembly 2T AssemblyS E M B LY Step YOU’RE FinishedOpen Hardware BAG Connect Console Wires 2T 5.2T AssemblyYOU Begin Open Hardware BAG Lift Running Deck to upright positionBefore YOU Begin Treadmill Operation 2T, 2 T Console Features & DisplayGetting Started / Selecting a Program 2T, 4 T, 5 T Console Features & Display LAP Profile Program ProfileO G R a M Manual Program ProfilesProgram Intervals O G R a M RollingO G R a M Golf Course O G R a M Weight LossO G R a M Race Program THR Zone 1Heart Rate Conditioning GuidelinesPerceived Exertion Level HandlebarsStretching Target Heart Rate Zone ChartP S the Importance of Warm UP & Cool Down Weekly LOG SheetsP S Achieving Your Fitness Goals Keeping AN Exercise DiaryTroubleshooting Treadmill TroubleshootingMonthly LOG Sheets Common Product QuestionsI N T E N a N C E Troubleshooting Heart RateAfter Each USE Daily Every WeekExclusions and Limitations Limited Home USE WarrantyFrame Lifetime Drive MOTOR/ELEVATION 25 YearsCustomer Tech Support

1.2T, 2.2T, 4.2T, 3.2T, 5.2T specifications

Horizon Fitness offers a range of treadmills that cater to diverse fitness levels and preferences, with the models 5.2T, 4.2T, 3.2T, 2.2T, and 1.2T being among the most popular. Each of these treadmills is designed with unique features and technology to enhance the workout experience, making them suitable for both beginners and seasoned athletes.

The Horizon Fitness 5.2T is the flagship model known for its robust design and advanced features. It boasts a powerful 2.75 CHP motor, allowing for speeds up to 12 mph and incline adjustments up to 12 levels. Its 20" x 60" running surface provides ample space for unrestricted movement. Additionally, the 5.2T is equipped with Bluetooth connectivity, enabling users to sync their devices with fitness apps for tracking and motivation. The integrated speakers and quick access buttons for incline and speed make workouts enjoyable and efficient.

Moving to the 4.2T model, it shares many features with the 5.2T but is designed for those looking for a slightly more compact option. The 4.2T also features a 2.75 CHP motor, albeit with a reduced running surface of 20" x 55". The adjustable incline and speed settings provide versatility for various workout styles, while its folding design offers convenient storage solutions.

The Horizon Fitness 3.2T is an excellent choice for budget-conscious fitness enthusiasts without sacrificing key features. It comes with a 2.5 CHP motor, a maximum speed of 10 mph, and an incline capability of 10 levels. With a running surface of 20" x 55", it’s ideal for walking, jogging, and light running. Moreover, the 3.2T also benefits from integrated Bluetooth technology and a user-friendly display for tracking workout metrics.

For those seeking a treadmill primarily for walking and light exercise, the 2.2T is tailored to fit this need. It is equipped with a 2.0 CHP motor and offers a modest maximum speed of 10 mph. Its compact design makes it suitable for smaller spaces, and while it lacks some advanced features, it remains a reliable option for maintaining an active lifestyle.

Lastly, the Horizon Fitness 1.2T is designed specifically for beginners or casual users. Featuring a 1.75 CHP motor, a maximum speed of 8 mph, and a lightweight frame, it allows users to ease into their fitness journey. The 1.2T may not offer the extensive features of its more advanced counterparts, but it provides a straightforward, effective way to achieve fitness goals.

In summary, Horizon Fitness treadmills, from the 5.2T to the 1.2T, offer a variety of features suitable for different fitness levels, making them a worthwhile investment for anyone looking to enhance their workout routine.