Horizon Fitness T35, T25 manual Assembly, Developing a Fitness Program

Page 8

T25_T35 owner’s guidev1.0.qxd 6/17/2004 2:28 PM Page 8

Assembly

UNPACKING

Take caution when handling and transporting this unit. Never open box when it is on its side. Once the banding straps have been removed, do not lift or transport this unit unless it is fully assembled and in the upright folded position, with the lock latch secure. Unpack the unit where it will be used. The enclosed treadmill is equipped with high-pressure shocks and may spring open if mishandled. See owner’s guide for reference. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY! Place your treadmill on a level flat surface. It is recommended that you place a protective covering on your floor.

PARTS (see illustration on previous page)

1 Power Cord

1 Safety Key

2 Water Bottle Holders

Left and right outer console mast boots

1 Hardware Pack (contents listed below)

TOOLS (included)

5mm Allen Wrench/Phillips Screw Driver

Flat Wrench

8mm Allen Wrench or 6mm Allen Wrench

Note: It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before completely tightening any ONE bolt.

HARDWARE

A) Linkage Arm

 

B) Console Assembly

45mm bolt

 

Bracket

Quantity: 2

 

40mm bolt

 

 

Quantity: 2

 

C) Console Assembly

D) Console Mast Boot

 

Bracket

 

16mm bolt

 

13mm nylon nut

 

Quantity: 6

 

Quantity: 2

 

 

CONTACT HORIZON FITNESS CUSTOMER ASSISTANCE CENTER; TOLL FREE @ 1-800-244-4192 OR VISIT www.horizonfitness.com

Developing A Fitness Program

TIPS

STRETCH FIRST

Before using your product, it is best to take a few minutes doing a few gentle stretching exercises. Stretching prior to exercise will improve flexibility and reduce chances of exercise related injury. Ease into each of these stretches with a slow gentle motion. Do not stretch to the point of pain. Make sure not to bounce while doing these stretches.

WALL PUSH

Stand near a wall with the toes of one foot about 18" from the wall, and the other foot about 12" behind the other foot. Lean forward, pushing against the wall with your palms. Keep your heels flat and hold this position for a count of 15 seconds. Make sure that you do not bounce while stretching. Alternate positions of your feet and repeat for a total of 8 repetitions.

STANDING QUADRICEPS STRETCH

Using a wall to provide balance, grasp your left ankle with your left hand and hold your foot against the back of your thigh for a count of 15 seconds. Repeat with your right ankle and hand, and contin- ue alternating for a total of 8 repetitions.

SEATED TOE TOUCH

Sit on the floor with your legs together and straight out in front of you. Do not lock your knees. Extend your fingers towards your toes and hold for a count of 15 seconds. Make sure that you do not bounce while stretching. Sit upright again. Repeat for a total of 8 repetitions.

7

28

Image 8
Contents Treadmill User’s Guide Horizon Fitness 800 Burton Boulevard DEFOREST, WIT25T35 owner’s guidev1.0.qxd 6/17/2004 228 PM Limited Warranty Table of ContentsGrounding Instructions Important PrecautionsMonthly Log Sheets Weekly Log Sheet Keeping AN Exercise Dairy Warranty RegistrationAchieving Your Fitness Goals Warm Up & Cool Down Before You BeginImportance of Warm UP and Cool Down Cool DownAssembly Developing a Fitness ProgramStep Lock Console Into Place Heart Rate ChartTarget Zone Treadmill Operation & Adjustment Conditioning GuidelinesCommon Product Questions Heart Rate Troubleshooting Tensioning the BeltCentering the Belt If the Belt is TOO FAR to the Left SideConsole Features & Display ResetQuick Start UP PauseTroubleshooting & Maintenance Procedures Choosing a Program Choosing the LevelSelect CaloriesDistance TimeProgram Charts ElevationSpeed Program ProfileProgram Profiles