Reebok Fitness RBTL13305.2 manual HOW to Fold and Move the Treadmill, HOW to Move the Treadmill

Page 22

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE

Before folding the treadmill, adjust the incline to the lowest position. If this is not done, the treadmill may be permanently damaged. Next, unplug the power cord. CAUTION: You must be able to safely lift 45 pounds (20 kg) to raise, lower, or move the treadmill.

1.Hold the treadmill in the locations shown at the right. To decrease the possibility of injury, bend your legs and keep your back straight. As you raise the frame, make sure to lift with your legs rather than your back. Raise the frame about halfway to the vertical position.

2.Hold the frame firmly with your left hand. Using your right hand, pull the latch knob to the right and hold it. Raise the treadmill until the pin on the latch knob is aligned with the hole in the left handgrip. Then, release the latch knob. Make sure that the latch knob is fully released so the pin is fully inserted into the hole in the left handgrip.

To protect the floor or carpet from damage, place a mat under the treadmill. Keep the treadmill out of direct sunlight. Do not leave the treadmill in the stor- age position in temperatures above 85° Fahrenheit.

HOW TO MOVE THE TREADMILL

Before moving the treadmill, convert the treadmill to the storage position as described above. Make sure that the pin on the latch knob is fully inserted into the hole in the left handgrip.

1.Hold the handgrips and place one foot against one of the wheels.

2.Tilt the treadmill back until it rolls freely on the wheels. Carefully move the treadmill to the desired location. To re- duce the risk of injury, use extreme caution while moving the treadmill. Do not attempt to move the treadmill over an uneven surface.

3.Place one foot against a wheel, and carefully lower the treadmill until the base is in the storage position.

HOW TO LOWER THE TREADMILL FOR USE

1

2

 

Frame

Latch

 

Latch

Knob

Pin

Knob

 

Handgrip

 

Pin

Handgrip

 

 

Base

 

Wheel

1.See drawing 2 above. Hold the treadmill frame firmly with your left hand. Pull the latch knob to the right. Pivot the frame down until the pin on the latch knob is below the handgrip. Then, slowly release the latch knob.

2.See drawing 1 above. Hold the frame firmly with both hands, and lower the frame to the floor. To decrease the possibility of injury, bend your legs and keep your back straight.

22

Image 22
Contents Call TOLL-FREE QUESTIONS?Model No. RBTL13305.2 Serial No Mon.-Fri., 6 a.m.-6 p.m. MSTTable of Contents Important Precautions Page Power Lines Service Before YOU Begin Right SideAssembly Page HOW to Connect a 75 OHM Catv Cable HOW to Connect AN External Source Using a Catv CableTreadmill Operation HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Features of the Console HOW to Turn on the Power HOW to USE the Manual ModeMeasure your heart rate if desired Turn on the fan if desiredHOW to USE a Preset Program Select a preset programFollow your progress with the displays HOW to Create a Custom Program Select a custom programHOW to USE a Custom Program Select a heart rate program HOW to USE a Heart Rate ProgramEnter your age Hold the handgrip pulse sensor Press the Volume buttons to adjust the volume HOW to Operate the Personal TelevisionPress the Power button to turn on Television HOW to USE the Information ModePress the Power button again and select a Cable connection Press the Power button again and add or Delete channelsHOW to Adjust the Cushioning System HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USEProblem The power turns off during use TroubleshootingProblem The walking belt slows when walked on Problem The displays of the console do not function properly Top View Problem Television reception is poorWorkout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencyR1107A Qty DescriptionOrdering Replacement Parts No. RBTL13305.2 Exploded Limited Warranty