PROBLEMSOLUTION
4.The walking belt is off-center or slips when walked on
a.If the walking belt is
a |
| b. If the walking belt slips when walked on, | b |
| |
| first remove the key and UNPLUG THE |
| ||
|
|
| ||
| POWER CORD. Using the allen wrench, |
|
| |
| turn both rear roller bolts clockwise 1/4 of a |
|
| |
| turn. When the walking belt is correctly |
|
| |
| tightened, you should be able to lift each |
|
| |
| side of the walking belt 7 to 10 cm (3 to 4 |
|
| |
| in.) off the walking platform. Be careful to |
|
| |
| keep the walking belt centered. Plug in the |
|
| |
| power cord, insert the key, and walk on the |
|
| |
| treadmill for a few minutes. Repeat until the walking belt is properly tightened. | |||
5. The displays of the a. Remove the key from the console and UN- | a |
| ||
console do not func- | PLUG THE POWER CORD. Next, remove |
| ||
3 mm |
| |||
tion properly | the screws from the hood and carefully re- |
| ||
44 | 11 | |||
| move the hood. Locate the Reed Switch | |||
|
| |||
|
| 12 | ||
| (17) and the Magnet (12) on the left side of | 17 | ||
| the Pulley (11). Turn the Pulley until the | Top |
| |
| Magnet is aligned with the Reed Switch. |
| ||
| Make sure that the gap between the | View |
| |
| Magnet and the Reed Switch is about 3 |
|
|
mm(1/8 in.). If necessary, loosen the indi-
cated Screw (44) and move the Reed Switch slightly. Retighten the Screw.
27