Handlebar Assembly
Note: During the handlebar assembly process it is best to wait to tighten all screws until after the handlebars are assembled.
1.(a.) Locate the Console Support Tube. This is a round tube with a bracket to mount the display console. The right end of the console has 1 wire connector coming out of the end. Push this connector through the round hole on the inside of the right side Handlebar Support Post and up through the top of the support post. Then push the end of the Console Support Tube into the support post as shown in illustration A below.
Insert the left end of the Console Support Tube in the round hole on the left Handlebar Support Post. To do this you will need to gently pull the Handlebar Support Posts apart so that you have enought clearance to insert the tube on the left side.
(b.) Push the 2 large connectors together. Make sure that the connectors are properly aligned and tightly pushed together.
(c.) Push the large connectors and extra wiring into the top of the Handlebar Support Post.
a |
| b |
| c |
Pull connectors to the top of the post and insert tube
Alig n and push together 2 large connectors
Push 2 large
connectors
into the post
2.Rotate the display support tube so that the display bracket matches the picture below. This will align a hole in the round display tube with the hole in the front of the support post. Tighten each of the two button head screws with washer and proceed to the next step.
As always, be careful not to pinch any wires with the screws.
Correct Display
Bracket Angle
Handlebar
Display Support
Tube Screws
(one on each side)
9