Woods Equipment 59CL-4, 59CLF-4 manual Idler Bracket Assembly See, Sheave for Belt Pulley Shaft See

cal push arms (31 and 40) and attachment brackets (32) and (39).

Idler Bracket Assembly (See Figure 9 & page 16)

Remove the cap screws from the PTO bearing plate. Bolt the idler bracket assembly (36, 37, 38 and 45) to the tractor using 3/8 x 1-1/2" cap screws and lock washers.

Sheave for Belt Pulley Shaft (See page 16)

Remove paint from bore of sheave (41). Put 1" splined tapered bushing in sheave (41) and insert screws to hold bushing in place, but DO NOT TIGHTEN. Slide sheave and bushing on PTO shaft and leave loose until belts are put on and lined up. After proper alignment is obtained, tighten bushing bolts evenly to 12 lbs-ft of torque, alternating back and forth at least six times.

Mount Mower (See page 16)

Slide mower under tractor, attach crosswise rear sup- port (35) to the two channel arms (33) using 5/8 x 1-1/2" clevis pins and safety pins (28).

Channel Arms (See page 16)

Attach two channel arms (33) with single bore hole end to the mower, using 5/8 x 1-1/2 clevis pins and safety pins. Use upper hole in arms for high grass. Attach channel arms to brackets (31 & 40) using 5/8 x 1-3/4 clevis pins.

Attach the crosswise rear support (35) to the mower frame using one 1/2 x 2" cap screw, pivot bushing (34) and flange lock nut.

Lifting Assembly (See page 16)

Attach the lift assembly to right hydraulic arm of the tractor, using two 5/8 x 1-3/4 cap screws, lock washer and nut.

Attach two 10-link lift chains (9) to the key holes in lift lugs on mower frame and secure with plastic caplug. Attach upper end of chains to the eye bolts of lift assembly.

Raise the mower on the tractor hydraulic system slightly and adjust the chain to carry the mower level. Adjust stops on lift control lever so mower will not hit tires or bottom of tractor when fully raised.

Belt Assembly & Adjustment

First put belt on bottom groove, right hand side of the center sheave. Then thread it to the left, around the left hand sheave.

Figure 3. Belt Installation

Bring the belt back across the center sheave in the center groove over to the right outside sheave.

Figure 4. Belt Installation

Then thread it back across the front of the center sheave in the top groove.

29929 (Rev. 3/28/2008) Assembly 11