SURROUND VOLUME
The SURROUND knob on the control pod controls the volume of the left and right surround speakers. Adjust this control as necessary to create the optimum sound. The surround volume control operates in the same manner even on computers that only have stereo outputs.
SUBWOOFER VOLUME
The SUBWOOFER knob on the control pod controls the volume of the subwoofer. Turn the knob clockwise to increase the subwoofer volume and counterclockwise to decrease the subwoofer volume.
CENTER VOLUME
The CENTER knob on the control pod controls the volume of the center speaker. Adjust this knob as necessary to achieve a balanced sound.
SYSTEM SPECIFICATIONS*
HEADPHONES
To use headphones with the system, plug them into the labeled jack on the control pod. When headphones are connected, the speaker system is muted.
Altec Lansing’s superior sound comes from our patented Dynamic EQ technology, which utilizes
Sound Pressure Level (SPL): | 103 dB | System Response: | 40 Hz – 20 kHz | ||
|
|
|
|
| |
Total Continuous Power: | 50 Watts RMS | Signal to Noise Ratio |
| ||
|
| @ 1 kHz input: | > 80 dB | ||
• Front Speakers: | 5 Watts/channel @ 8 ohms | ||||
|
|
| |||
| @ 10% THD @ 150 Hz – 20 kHz | Drivers (per satellite): | One 2" | ||
| 2 Channels Loaded |
|
|
| |
| Subwoofer: | One 5.25" woofer | |||
|
| ||||
• Rear Speakers: | 5 Watts/channel @ 8 ohms |
|
|
| |
| @ 10% THD @ 150 Hz – 20 kHz | POWER REQUIREMENTS |
| ||
| 2 Channels Loaded |
| |||
|
|
|
| ||
| USA, Canada and applicable |
| |||
|
|
| |||
• Center Speaker: | 10 Watts @ 8 ohms |
| |||
Latin American countries: | 120 V AC @ 60 Hz | ||||
| @ 10% THD @ 150 Hz – 20 kHz | ||||
|
|
|
| ||
| Europe, United Kingdom, |
| |||
| Single Channel Loaded |
| |||
| applicable Asian countries, |
| |||
|
|
| |||
• Subwoofer: | 20 Watts @ 8 ohms |
| |||
Argentina, Chile and Uruguay: | 230 V AC @ 50 Hz | ||||
| @ 10% THD @ 40 – 150 Hz | ||||
|
|
|
| ||
| ETL/cETL/CE/NOM Approved |
| |||
| Single Channel Loaded |
| |||
|
|
|
|
*Power rating conforms to FTC Amplifier Rule #16 C.F.R. Part 432.
TROUBLESHOOTING
SYMPTOM | POSSIBLE PROBLEM | SOLUTION |
No LEDs are lit. | Power isn’t turned on. | Turn on the speaker system by pushing the On/Off button located on the |
|
| control pod. An LED will light on the control pod when the power is ON. |
|
|
|
| AC power cord isn’t connected to the wall outlet. | Check to see if the “Power On” LED is illuminated on the control pod. If not, |
|
| connect AC power. |
|
|
|
| Surge protector (if used) isn’t powered on. | If the AC power cord is plugged into a surge protector, make sure the surge |
|
| protector is switched on. |
|
|
|
| Wall outlet not functioning. | Plug another device into the wall outlet (same jack) to verify the wall outlet is |
|
| working. |
|
|
|
3