Woods Equipment 59CL-4, 59CLF-4 manual Belt Shield See, Casters, Leaf Mulcher

Wrong: Outer edge of belt appears to be in line.

Figure 8. Incorrect Alignment

V-Belt Shield (See page 16)

Place the V-belt shield (43) over the rear drive and secure with wing nut.

Casters

The caster bundle includes one right and one left caster assembly, which, on most tractors, is assembled with the offset away from front wheels, but on 59CL mounted on IH Cub Lo-Boy, the left caster must be off- set away from carburetor on the tractor. Therefore, right caster will offset outward toward front tire. The front tractor wheels should be moved out about 6" from narrowest position to provide room for caster wheel to turn when backing up.

Leaf Mulcher

Turn mower upside down on saw horses. If mower has a bolt-on front shield, adjust shield all the way down in

long slots. Remove side shields. Leave side skids on. If optional front roller has been installed, it must be removed.

On mowers with bent-down front frame, remove center baffle and drill two 7/16 diameter holes in front of mower at the dimensions shown on page 21.

Attach slotted angles (2) to leaf mulcher as shown in drawing.

Place leaf mulcher over blades on mower. Attach angles (2) to mower side shields to side frame angle on mower. Mowers with bolt-on front shields will use front shield hole to attach angle (2). Bolt side shields to mower using 3/8 flat washers for spacers.

On mowers with bolt-on front shield, bolt front of leaf mulcher to bottom of slots in front shield with 3/8 x 1" bolts and flat washers. On mowers with bent-down front frame, bolt leaf mulcher to inside of mower in holes drilled in front frame using 3/8 x 1-1/2" bolts and 5/8 long pipe spacers between leaf mulcher and mower. On some mowers where 5/8" pipe may be too long, substitute 3/8 flat washers.

Drill 7/16 holes in rear of mower deck through holes in leaf mulcher rear plates and bolt rear of leaf mulcher to deck using 3/8 x 1" bolts.

Tighten all bolts securely. Turn each blade individually inside the leaf mulcher to see that it clears the leaf mulcher rings. If necessary, the rings may be re- shaped with a hammer to clear the leaf mulcher rings.

Figure 9. 59CL-4 Idler Bracket and Mounting Assembly Photo

29929 (Rev. 3/28/2008) Assembly 13