3.With the help of a second person, hold the Console (11 ) near the right Upright (14) as shown.
Insert the Wire Harness (26) into the Right Upright (14).
Route the Wire Harness (26) through the notch in the bracket on the dght Handrail (2) as shown. Insert the bracket into the right Upright (14). Make sure that the
Wire Harness is not pinched.
4. Set the Handrails (2) on the Uprights (14) as shown.
Bracket._ 12
4
Thread a Handrail Bolt (15) with a Handrail Washer (16) into each Upright and Handrail. Do not tighter= the Hsndrail Bolts yet.
Tighten a Handrail Screw (32) into the lower end ol each Handrail (2), Be sure to push on the heads of the Handrail Screws while tightening them. Next. tighte_ the Handrail Bolts (15).
5.Attach the Storage Latch (12) 1o the left Upright (14) with two Latch Screws (13). Be careful not to overtighten the Latch Screws.
6.Remove the backing from the Adhesive Clip (74). Press the Adhesive Clip onto the base of the Uprights (14} in the indicated location. Press the AIMn Wrench (73) into the Adhesive Clip.
7.Make sure that all parts are tightened before you use
the treadmill, TO protect the floor or carpet, place a
Bmat under the treadmgl.