Spirit Z9 owner manual Service Checklist Diagnosis Guide, Problem SOLUTION/CAUSE

Page 20

unit. See your Spirit dealer for additional purchases. The use of some other lubricants may destroy the deck surface or belt and will void warranty. Conditions exist beyond Spirit’s control on belt / deck cleanliness which relates to friction.

You should apply the enclosed belt lubrication after approximately the first 50 hours of operation. Use all the contents of one container (no more) and spread lubricant onto middle portion (away from edges) of the deck (under treadbelt) along its width. When walked on, the belt will make certain an even coat is applied. Lubricant is not harmful to the skin. Lube will be distributed properly by walking at 2 to 3 mph for 3 to 5 minutes on all areas of the belt. Use handrails for support. The first few minutes you will be polishing your deck and lubricating the belt backing. Do not run on a newly lubricated belt until the above break-in procedure is done. If the treadmill belt/deck is kept reasonably clean it is possible to expect over 1000 hours before additional re-lubing is necessary.

CAUTION - KEEP HANDS CLEAR OF MOVING REAR PULLEY!

Service Checklist - Diagnosis Guide

Before contacting your dealer for aid, please review the following information. It may save you both time and expense. This list includes common problems that may not be covered under the treadmill’s warranty.

 

PROBLEM

SOLUTION/CAUSE

 

 

 

 

 

 

Display does not light

Tether cord not in position.

 

 

Circuit breaker on front grill tripped. Push circuit

 

 

breaker in until it locks.

 

 

Plug is disconnected. Make sure plug is firmly pushed

 

 

into AC household wall outlet.

 

 

Household circuit breaker may be tripped.

 

 

Treadmill defect. Contact your Spirit dealer.

 

 

 

 

 

 

Treadbelt does not stay centered

 

 

 

 

Treadmill belt hesitates when walked/run on

A user may be walking while favoring or putting more

 

 

weight on either the left or right foot. If this walking

 

 

pattern is natural, track the belt slightly off-center to

 

 

the side opposite from the belt movement. See

 

 

General Maintenance section on Treadbelt Tension.

 

 

Adjust as necessary.

 

 

 

 

 

 

Motor is not responsive / Display is lit

Make certain clock is running.

 

 

 

 

 

Treadmill will only achieve approximately 7 mph but shows higher speed on display

This indicates motor should be receiving power to operate. Low AC voltage to treadmill. Do not use an extension cord. If an extension cord is required it should be as short as possible and heavy duty 16 gauge minimum. Low household voltage. Contact an electrician or your Spirit dealer. A minimum of 110 volt AC current is required.

19

Z9

Image 20
Contents Page Table of Contents Product Registration Register Your PurchaseImportant Safety Instructions Important Electrical Information Safety Tether Cord Important Operation InstructionsAssembly Instructions Z9 Assembly Pack Check ListZ9 Folding Instructions TransportOperation of Your Treadmill Window DisplayFunction Buttons DOWN:Console Operation ProgramP1 Manual U1 ~ U3 User Setting P1 MANUAL: Error Message Programmable Operation of Your TreadmillUsing a Heart Rate Transmitter Erratic OperationHeart Rate Control Special Operations of Heart Rate FunctionsGeneral Maintenance Belt AdjustmentsBelt / Deck Lubrication Treadbelt Tracking AdjustmentTo SET Treadbelt Tracking Service Checklist Diagnosis Guide Problem SOLUTION/CAUSEManufacturer’s Limited Warranty Treadmill WarrantyService