familiar with its function and limitations. The treadmill will stop, depending on speed, with a one to two step coast anytime the magnet is pulled off the console. Use the red Stop / Pause switch in normal operation.
Assembly Instructions (Z9)
ASSEMBLY PACK CHECK LIST
5/16"x 1/2" Button Head Socket Screw (14pcs)
5/16” x 18 x 1.5T Flat Washer (6pcs)
5/16” x 23 x 1.5T Curve Washer (2pcs)
Safety Key (1pc)
Lubricant (1pc)
M5 Allen Wrench (1pc)
M6 Allen Wrench (1pc)
Assembly
■STEP 1
Remove all parts from the carton.
■STEP 2
Connect Computer Cable (middle) with Computer cable (lower).
■STEP 3
Hand tighten the Left and Right Handrails into the Base with 8 pcs of 5/16” x 1/2” Button Head Socket Screws, 6 pcs of 5/16” x 18 x 1.5T Flat Washers and 2pcs of 5/16”x 23x1.5T Curve Washers by using the M5 Allen Wrench.
■STEP 4
Connect Speed Adjustment Switch w/Cable with Speed Cable (middle). And connect Incline Adjustment Switch w/Cable with Incline Cable (middle).
■STEP 5
Hand tighten the Left and Right Handrails with 4 pcs of 5/16” x 1/2” Button Head Socket Screws by using the M5 Allen Wrench.
■STEP 6
Connect 12 pin 1300 mm Computer Cable (middle) with 12 pin 800 mm Computer cable (upper).
Connect Speed Cable (middle) with Speed Cable (upper) and Incline Cable (middle)
6 | Z9 |