Service Checklist - Diagnosis Guide
Before contacting your dealer for aid, please review the following information. It may save you both time and expense. This list includes common problems that may not be covered under the treadmills warranty.
PROBLEM | SOLUTION/CAUSE |
Display does not light | Tether cord not in position. |
| Circuit breaker on front grill tripped. Push circuit breaker in |
| until it locks. |
| Plug is disconnected. Make sure plug is firmly pushed into the |
| AC household wall outlet. |
| Household circuit breaker may be tripped. |
| Treadmill defect. Contact your Spirit dealer. |
Treadmill belt does not stay centered Treadmill belt hesitates when walked/run on
A user may be walking while favoring or putting more weight on either the left or right foot. If this walking pattern is natural, track the belt slightly
Motor is not responsive / Display is lit | Make certain clock is running. If it is then service may be |
| Needed. |
|
|
Treadmill will only achieve approximately 7 mph but shows higher speed on display
This indicates motor should be receiving power to operate. Low AC voltage to treadmill. Do not use an extension cord. If an extension cord is required it should be as short as possible and heavy duty 16 gauge minimum. Low household voltage. Contact an electrician or your Spirit dealer. A minimum of 110 volt AC current is required.
Treadmill belt stops quickly/suddenly when tether cord is pulled
High belt/deck friction. See General Maintenance section on lubrication.
Treadmill trips on board 15 amp circuit | High belt/deck friction. See Belt/deck lubrication procedure |
Computer shuts off when console is touched (on a cold day)while walking/running
Treadmill is not grounded. Static electricity is crashing the computer. Refer to Grounding Instructions on page 4.
ERROR MESSAGES:
1.LS: The treadmill hasnt received a speed signal for 8 seconds.
2.E1: Incline position error.
3.E2: Console memory malfunction or CPU accessing problem.
26 | ET2 / ET4 |