If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the re- ceiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated 3/4" Screws (4) from the Pulse Receiver Cover (70) on the back of the Console Assembly (A).
2.Next, hold the receiver so the small cylinder is oriented as shown. Attach the receiver to the Pulse Receiver Cover (70) with the two included Small Screws (B).
1 |
A |
70 |
4 |
2 |
B |
Cylinder
70
3.Connect the Wire (C) on the receiver to the wire extending from the Console Assembly (A). Make sure that no wires are pinched. Reattach the Pulse Receiver Cover (70) to the Console Assembly with the two 3/4" Screws (4). Discard the other wires included with the receiver.
3 |
|
|
|
| Wire |
A | Tab | C |
|
| |
|
| 70 |
|
| 4 |
11