Gold's Gym GGTL03607.5 manual Make sure that the power cord is unplugged

1.	Make sure that the power cord is unplugged.	1
	With the help of a second person, carefully tip				77	Hole
	the treadmill onto its left side. Partially fold the
	Frame (48) so that the treadmill is more stable;					81
	do not fully fold the Frame yet.		48					2
	Cut the shipping tie securing the Upright Wire
	(77) to the Base (85). Next, locate the plastic tie					85
	in the indicated hole in the Base, and use the
	plastic tie to pull the Upright Wire out of the hole.
	Attach a Base Pad (81) to the Base (85) in the		64
	location shown with an M4.2 x 25mm Tek Screw			81	2
	(2) and a Base Pad Spacer (64). Then, attach
	another Base Pad (81) with only an M4.2 x
	25mm Tek Screw (2).
2. Attach a Wheel (86) to the Base (85) with an		2
	M10 x 50mm Bolt (27) and an M10 Nut (33). Do
	not overtighten the Nut; the Wheel must turn
	freely.
			27
					86	85
					33
3. Identify the Right Upright (78) and the Right		3				Wire Tie
	Upright Spacer (80), which are marked with
	stickers. Insert the Upright Wire (77) through the					78
	Right Upright Spacer as shown. Then, set the
	Right Upright Spacer on the Base (85).		77					77
	Have a second person hold the Right Upright
	(78) near the Base (85). See the inset drawing.							80
	Tie the wire tie in the Right Upright securely
	around the end of the Upright Wire (77). Then,
	pull the other end of the wire tie until the Upright
	Wire is routed completely through the Right
	Upright.						85
				78
		77		Wire
				Tie
		7