7.Attach the Latch Insert (70) to the Left Upright (73) with two #10 x 1" Tek Screws (76). Make sure that the large hole in the Latch Insert is on the side shown. Do not overtighten the Tek Screws.
Locate the Latch Pin Assembly (72). Remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Insert the pin into the Latch Insert (70), and tighten the knob back onto the pin.
7
72 | 70 |
| 73 | |
Knob | 76 |
|
| Collar |
|
| Spring | Pin | |
Large Hole | ||||
8.Hold the Right Handrail (90) near the Right Upright (78). Insert the Upright Wire (77) into the opening in the bot- tom of the Right Handrail and out of the indicated hole in the top.
Set the Right Handrail (90) on the Right Upright (78), and finger tighten three M8 x 19mm Bolts (6) with three M8 Star Washers (10) into the Right Handrail and the Right Upright. Do not fully tighten the Bolts yet. Make sure that the Upright Wire (77) is not pinched. Attach the Left Handrail (89) to the Left Upright (73) as described above. Note: There are no wires on the left side.
9.Have another person hold the console assembly near the Right Handrail (90). Attach the end of the ground wire to the indicated small hole in the Right Handrail with the M4.2 x 13mm Silver Screw (4).
Connect the Upright Wire (77) to the console wire. See the inset drawing. The connectors should slide to- gether easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
Remove the wire tie from the Upright Wire (77).
8 | 89 |
|
|
|
|
|
|
| 77 Hole90 | ||
6 |
|
|
| ||
10 | 6 | 6 | 10 | 6 | |
73 |
|
|
|
| 10 |
|
|
|
|
| |
|
|
|
| 78 |
|
9 |
|
| Console Assembly | ||
Console | 4 |
|
| Ground |
|
Wire |
|
| Wire |
| |
77 |
|
|
| Small Hole | |
|
|
| 90 | Console |
|
| Wire | Wire |
| ||
|
|
| |||
|
| Tie | 77 |
| |
|
|
|
|
| |
9