TROUBLE-SHOOTING AND MAINTENANCE
Most treadmill problems can be solved by following the instructions below. If further assistance is needed, please call our Customer Service Department
PROBLEMSOLUTION
1.The power does not turn on
a.Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into a properly grounded outlet. (See page 7.) Use only a
b.Make sure that the key is fully inserted into the console.
c.Check the circuit breaker located on the frame near the 
power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.
Tripped Reset
d.Check the on/off switch located on the frame near the power cord. The switch must be in the on position.
On
Position
| a. Check the circuit breaker located on the treadmill frame near the power cord (see | ||||||||
| 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press | ||||||||
2. The power turns off | the switch back in. |
|
|
|
|
|
|
|
|
during use |
|
|
|
|
|
|
|
|
|
| b. Make sure that the power cord is plugged in. |
|
|
|
|
|
|
|
|
| c. Remove the key from the console and then reinsert it. | ||||||||
| d. Make sure that the on/off switch is in the on position (see 1. d. above). | ||||||||
|
|
|
|
|
|
|
|
|
|
| a. Make sure that only an appropriate surge protector is used (see 1. a. above). | ||||||||
3. The walking belt | b. If the walking belt is overtightened, treadmill performance may decrease and the | ||||||||
slows when walked | walking belt may be permanently damaged. Remove the key and UNPLUG THE | ||||||||
on | POWER CORD. Using the included allen |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
| b |
|
|
|
|
| |||
| wrench, turn both rear roller adjustment |
|
|
|
|
| |||
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
| bolts counterclockwise 1/4 of a turn. |
|
|
|
|
|
| ||
| When the walking belt is properly tight- |
|
|
|
|
|
|
|
|
| ened, you should be able to lift the edges |
|
|
|
|
|
|
|
|
| of the walking belt 3 to 4 inches off the |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| walking platform. Be careful to keep the |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| walking belt centered. Plug in the power |
|
|
|
|
|
|
|
|
| cord, insert the key and run the treadmill |
|
|
|
|
|
|
|
|
|
|
| Rear Roller Adjustment Bolts | ||||||
| for a few minutes. Repeat until the walk- |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
| ing belt is properly tightened. |
|
|
|
|
|
|
|
|
25