Displays, Bubbles form in the walking belt

PROBLEMSOLUTION

4.The walking belt is off-center or slips when walked on

a.If the walking belt has shifted to the left, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left rear roller adjustment bolt clockwise, and the right bolt counter- clockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centered.

b.If the walking belt has shifted to the right, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left rear roller adjustment bolt counterclockwise, and the right bolt clockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centered.

c. If the walking belt slips when walked

on, first remove the key and UNPLUG

THE POWER CORD. Using the allen

wrench, turn both rear roller adjustment

bolts clockwise, 1/4 of a turn. When the

walking belt is correctly tightened, you

should be able to lift the edges of the

walking belt 3 to 4 inches off the walking

platform. Be careful to keep the walking

belt centered. Plug in the power cord, in-

sert the key and run the treadmill for a few minutes. Repeat until the walking belt

is properly tightened.

5. The displays of the

a. Remove the key from the console and UN-

console do not func-

PLUG THE POWER CORD. Next, remove

1/8”

tion properly

the screws from the hood and carefully re-

move the hood. Locate the Reed Switch

(26) and the Magnet (85) on the left side of

the Pulley (28). Turn the Pulley until the

Magnet is aligned with the Reed Switch.

Top

Make sure that the gap between the

View

Magnet and the Reed Switch is about

1/8”. If necessary, loosen the Reed Switch

Screw (20) and move the Reed Switch slightly. Retighten the Screw. Re-attach the

hood and run the treadmill for a few minutes to check for a correct speed reading.

6.Bubbles form in the walking belt

a.Due to variations in humidity and temperature, there is a possibility that bubbles may form in the walking belt. Although the bubbles will disappear with time, you may unplug the power cord, carefully insert a needle into the bubbles, and push the air out of the bubbles.