TROUBLE-SHOOTING and Maintenance

Most treadmill problems can be solved by following the simple steps below. If further assistance is needed, call our toll-free HELPLINE at 1-800-736-6879, Monday through Saturday, 7 a.m. until 7 p.m. Central Time (excluding holidays).

PROBLEMSOLUTION

1.The power does not turn on

a.Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 7). Use only a single-outlet surge suppressor that is UL 1449 listed as a transient voltage surge suppressor (TVSS). The surge suppressor must have a UL suppressed voltage rating of 400 volts or less and a minimum surge dissipation of 450 joules. The surge suppressor must be electrically rated for 120 volts AC and 15 amps.

b.Make sure that the key is fully inserted into the console.

c.Check the circuit breaker located on the frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

d.Check the on/off switch located on the frame near the power cord. The switch must be in the ÒonÓ po- sition.

Tripped Reset

ÒOnÓ Position

2.The power turns off during use

a.Check the circuit breaker (see c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in.

c.Remove the key from the console and then reinsert it.

d.Make sure that the on/off switch is in the ÒonÓ position (see d. above).

3. The walking belt	a. Use only a single-outlet surge suppressor that is UL 1449 listed as a transient
slows when walked	voltage surge suppressor (TVSS). The surge suppressor must have a UL sup-
on	pressed voltage rating of 400 volts or less and a minimum surge dissipation of 450
	joules. The surge suppressor must be electrically rated for 120 volts AC and 15
	amps.
	b. If the walking belt is overtightened, tread-
	b. If the walking belt is overtightened, tread-
	mill performance may decrease and the	b		3Ð4Ó
	mill performance may decrease and the
	walking belt may be permanently dam-


	aged. Remove the key and UNPLUG THE
	POWER CORD. Using the included allen
	POWER CORD. Using the included allen
	wrench, turn both rear roller adjustment
	bolts counterclockwise 1/4 of a turn. When
	the walking belt is properly tightened, you
	should be able to lift the edges of the
	should be able to lift the edges of the		Rear Roller Adjustment Bolts
	walking belt 3 to 4 inches off the walking		Rear Roller Adjustment Bolts


	platform. Be careful to keep the walking
	belt centered. Plug in the power cord, insert the key and run the treadmill for a few
	minutes. Repeat until the walking belt is properly tightened.