JVC UX-H35 manual With the source to play, Adjust the clock if you need, Press STANDBY/ON

Page 24

4Select the timer (Daily Timer or Recording Timer)

with the source to play.

On the remote control:

Press UP or DOWN to select the timer, then press

CLOCK/TIMER.

On the unit:

Press ¢ or 4 to select the timer, then press TIMER/SNOOZE.

•Each time you press UP

(¢) or DOWN (4), the timer mode and the source change as follows:

UP

DOWN

CLOCK / TIMER

TIMER/SNOOZE

6Adjust the clock if you need.

• See “Setting the Clock” on page 10.

7 Press STANDBY/ON

STANDBY/ON

(or

on the unit) to turn

 

off the unit (standby) if you

 

have set the timer with the

 

unit turned on.

 

•When the timer turns on the unit, the (timer) indicator starts flashing. (If the Recording Timer is selected in step 4, the REC indicator also starts flashing.)

To deactivate the timer temporarily,

CLOCK

 

/ TIMER

REC

TUNER TUNER

TAPE CD

TUNER : tunes in to the last station you were listening to. (Daily Timer)

REC TUNER : records the last station you were listening to. (Recording Timer)

• Put a recordable cassette into the deck.

CD : plays a disc. (Daily Timer)

• Load a disc.

TAPE : plays a tape. (Daily Timer)

•Make sure that the tape is in the cassette deck.

•Make sure that the tape direction is correct.

The unit enters the volume level setting mode.

5Select the volume level.

On the remote control:

Press UP or DOWN to set the volume level, then press CLOCK/TIMER.

On the unit:

Press ¢ or 4 to set the volume level, then press TIMER/SNOOZE.

•You can select the volume level (“VOLUME – –” and “VOLUME 0” to “VOLUME 40”).

If you select “VOLUME – –,” the volume is set to the previous level when the unit was turned off.

•To turn off the volume while the Recording Timer (REC TUNER) is working, set the volume level “VOLUME 0.”

The unit enters the clock setting mode.

press and hold CLOCK/TIMER (or

TIMER/SNOOZE on the unit) until the (timer) indicator on the display goes off.

TIMER/SNOOZE

To activate or change the timer

(with the previous setting), follow steps 1 to 7 on pages 20 and 21.

•If you want to change the timer setting after the Daily Timer be used, first deactivate the timer.

•If the unit is turned on when the timer on-time comes Timer does not work.

•When you unplug the power cord or if a power failure occurs

The timer will be canceled. You need to set the clock first, then the timer again.

21

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Micro Component System Page Important for Laser Products Precautions IntroductionAbout This Manual Contents Location of the Buttons Main UnitTop view Front viewDisplay window Main unit Display windowRemote Control Pressing one of these buttons also turns on the unitSupplied Accessories Connecting AntennasGetting Started FM antennaConnecting Speakers Turn the AM loop antenna until you have the best receptionRelease your finger from the clamp To connect an outdoor AM antennaConnecting Other Equipment To connect the AC power cordTo remove the speaker grilles To connect an audio equipmentPutting the Batteries into the Remote Control When using the unit in your carSetting the Clock Common OperationsTurning On the Power Adjusting the VolumeAdjusting the Tone Bass/Treble Reinforcing the Bass SoundTuning in to a Station Presetting StationsListening to FM and AM Broadcasts Tuning in to a Preset Station Tune in to the station you want to presetPress SET Press SET againWhen playing a CD-R or CD-RW Playing Back DiscsPress 0 Open on the unit General notesBasic Disc Operations Programming the Playing Order of the Tracks-Program PlayTo check the program contents Playing at Random-Random PlayRepeating Tracks-Repeat Play Press RandomPlaying Back Tapes Playing Back a TapePress for cassette deck on the unit Put a cassette in with the exposed part of the tape downTo record on both sides-Reverse Mode RecordingRecording on a Tape To protect your recordingDisc Direct Recording One Track RecordingPress ONE Touch Repeat steps 2 and 3 to record other tracks you wantUsing the Timers Using Daily Timer and Recording TimerSet the on-time when you want the unit To turn on Set the off-time when you want the unit To turn off standbyAdjust the clock if you need Select the volume levelTo deactivate the timer temporarily With the source to playUsing Snooze Timer Using Sleep TimerHow the Sleep Timer actually works Press SleepMaintenance Cleaning the unitHandling cassette tapes Handling discsTroubleshooting Specifications0403MWMMDWJEM
Top Page Image Contents