JVC UX-H35 manual Getting Started, Supplied Accessories, Connecting Antennas, FM antenna

Page 9

Getting Started

Continued

Supplied Accessories

Make sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied.

•AM loop antenna (1)

•FM antenna (1)

•AC power cord (1)

•Remote control (1)

•Batteries (2)

If anything is missing, consult your dealer immediately.

Connecting Antennas

FM antenna

FM antenna (supplied)

1Attach the FM antenna to the FM COAXIAL 75 Ω terminal.

2Extend the FM antenna.

3Fasten it up in the position which gives you the best reception, then fix it on the wall, etc.

About the supplied FM antenna

The FM antenna supplied with this unit can be used as temporary measure. If reception is poor, you can connect an outdoor FM antenna.

To connect an outdoor FM antenna

Before connecting the antenna, disconnect the supplied FM antenna.

Outdoor FM antenna

(not supplied)

Coaxial cable (not supplied)

A 75 Ω antenna with coaxial type connector

(IEC or DIN 45325) should be used.

Image 9

Contents Micro Component System Page Important for Laser Products Precautions IntroductionAbout This Manual Contents Main Unit Location of the ButtonsTop view Front viewMain unit Display window Display windowPressing one of these buttons also turns on the unit Remote ControlConnecting Antennas Supplied AccessoriesGetting Started FM antennaTurn the AM loop antenna until you have the best reception Connecting SpeakersRelease your finger from the clamp To connect an outdoor AM antennaTo connect the AC power cord Connecting Other EquipmentTo remove the speaker grilles To connect an audio equipmentWhen using the unit in your car Putting the Batteries into the Remote ControlCommon Operations Setting the ClockAdjusting the Volume Turning On the PowerAdjusting the Tone Bass/Treble Reinforcing the Bass SoundTuning in to a Station Presetting StationsListening to FM and AM Broadcasts Tune in to the station you want to preset Tuning in to a Preset StationPress SET Press SET againPlaying Back Discs When playing a CD-R or CD-RWPress 0 Open on the unit General notesProgramming the Playing Order of the Tracks-Program Play Basic Disc OperationsPlaying at Random-Random Play To check the program contentsRepeating Tracks-Repeat Play Press RandomPlaying Back a Tape Playing Back TapesPress for cassette deck on the unit Put a cassette in with the exposed part of the tape downRecording To record on both sides-Reverse ModeRecording on a Tape To protect your recordingOne Track Recording Disc Direct RecordingPress ONE Touch Repeat steps 2 and 3 to record other tracks you wantUsing Daily Timer and Recording Timer Using the TimersSet the on-time when you want the unit To turn on Set the off-time when you want the unit To turn off standbySelect the volume level Adjust the clock if you needTo deactivate the timer temporarily With the source to playUsing Sleep Timer Using Snooze TimerHow the Sleep Timer actually works Press SleepCleaning the unit MaintenanceHandling cassette tapes Handling discsSpecifications Troubleshooting0403MWMMDWJEM