6.Press a 50mm Square Inner Cap (15) into the top end of the Upright (4).
Attach a set of Pads (16, 31) to a Pad Bracket (6)
with four M6 x 16mm Screws (22). Make sure the Pads and Pad Bracket are oriented as
shown. Repeat with the other set of Pads and Pad Bracket.
Attach a Pad Bracket (6) to the top of the Upright
(4)with two M10 x 70mm Carriage Bolts (23), two M10 Washers (24), and two M10 Nylon Locknuts
Attach the other Pad Bracket (6) to the indicated side of the Upright (4) with two M10 x 70mm Carriage Bolts (23) and two M10 Nylon Locknuts (26).
7.Wet the handle on the Upright (4) with soapy water. Slide the Handle Grip (28) onto the handle. Slide the 60mm Square Bushing (10) onto the
bottom of the Upright. | Make sure the tabs are |
on the indicated sides. |
|
Press the 55mm Square Bushing (14) into the bottom of the Upright (4). Secure the Bushing
with two M4 x 16mm
Have one person press the tabs on the 60mm
Square Bushing (10) into the indicated hole in the Upright (4) while a second person slides the Upright and Bushing into the Backrest Frame (3). Engage the tabs on the Bushing into the slots in
the Frame. Be careful not to pinch your hands as you slide the Bushing into the Frame.
Thread the Upright Collar (34) into the Backrest Frame (3). Pull the Upright Adjustment Knob (17) out, and use a wrench to fully tighten the Collar into the Backrest Frame. Engage the Knob into a hole in the Upright (4), and tighten it fully.
8.Make sure that all parts are properly tightened before you use the weight bench. The use of
all remaining parts will be explained in ADJUSTMENTS, starting on the next page.
6 | 22 | 23 |
|
|
|
|
| ||
| Straight |
| 22 |
|
| Edge |
|
|
|
|
|
|
| 6 |
| 16 |
|
|
|
|
|
|
| 31 |
|
|
| 15 |
|
| Handle | 24 | 31 | 6 |
|
|
|
| |
|
| 26 |
| 26 |
| 23 |
|
|
|
| 4 | Straight | 16 | |
|
| Edge | ||
7 |
|
|
|
|
| 28 |
|
|
|
| 4 |
|
|
|
| 27 |
| 27 |
|
| Hole |
|
|
|
| Tab | 10 |
|
|
| 14 | 34 |
| |
| Slot |
| 17 |
|
|
|
|
| |
|
| 3 |
|
|
8