Assembly

To hire an authorized service technician to assemble the exercise cycle, call 1-800-445-2480.

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack- ing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included

tools, assembly requires a Phillips screwdriver , an adjustable wrench , and

a rubber mallet .

As you assemble the exercise cycle, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the hardware kit, check to see if it has been pre-assembled.

M10 Nylon	M10 Split	Black M10 Curved	M10 Curved
Locknut (48)–2	Washer (63)–3	Washer (61)–2	Washer (36)–2
M4 x 16mm	M4 x 19mm	M6 x 10mm	Black M10 x 50mm Button
Screw (58)–4	Screw (33)–2	Screw (60)–2	Screw (64)–2
M10 x 50mm Button		M10 x 85mm Button
Screw (46)–3		Screw (56)–4