1.Before beginning assembly, make sure that you have read and understand the information on page 4.
Attach one of the Stabilizers (31) to the Main Frame
(1) with two M6 x 60mm Bolts (53), two M6 Flat Washers (55), and two M6 Hex Nuts (54).
2.Attach the other Stabilizer (31) to the Main Frame
(1) with two M6 x 60mm Bolts (53), two M6 Flat Washers (55), and two M6 Hex Nuts (54).
3.Attach the Front Cover Panel (34) to the Main Frame (1) using four Fastener Bases (45) and four Fastener Pins (58). First, insert the Fastener Bases through the Cover Panel and into the Main Frame. Next, push a Fastener Pin (58) into the hole in each Fastener Base until it is flush with the Base.
4.Lubricate an Frame Axle (13). Attach the Handlebar Swing Arm (5) to the Main Frame (1) with the Frame Axle, two Rubber Washers (51), and two Axle Fasteners (56).
Note: If the ends of the Frame Axles (13) are internally threaded, the Axle Fasteners (56) will be bolts; if the ends are externally threaded, the Axle Fasteners will be acorn nuts (see the PART IDENTIFICATION CHART on page 4).
1 |
| |
1 |
| |
| 54 | |
31 |
| |
55 |
| |
53 |
| |
2 |
| |
| 1 | |
| 53 | |
| 55 | |
| 31 | |
54 |
| |
3 |
| |
45 | 1 | |
| ||
58 |
| |
45 |
| |
58 | 34 | |
45 | ||
4 |
| |
5 | ||
| ||
56 | 51 | |
51 | ||
56 | ||
1 |
|
5