Maintenance 
To get the best performance of the System, keep your discs, tapes and mechanism clean.
Handling discs
•Remove the disc from its case by holding it at the edge while pressing the center hole lightly.
•Do not touch the shiny surface of the disc, or bend the disc.
•Put the disc back in its case after use to prevent warping.
•Be careful not to scratch the surface of the disc when placing it back in its case.
•Avoid exposure to direct sunlight, extreme temperatures, and moisture.
To clean the disc:
Wipe the disc with a soft cloth in a straight line from center to edge.
Handling cassette tapes
•If the tape is loose in its cassette, take up the slack by inserting a pencil in one of the reels and rotate it.
–If the tape is loose, it may get stretched, cut, or caught in the cassette.
•Be careful not to touch the tape surface.
•Avoid the following places to store the
To keep the best recording and playback sound quality:
•Use a cotton swab moistened with alcohol to clean the heads, capstans and pinch rollers.
•Use a head demagnetizer (available at electronics and audio shops) to demagnetize the heads (when the System is turned off).
To protect your recording
Cassettes have two small tabs on the back to protect from unexpected erasure or re- recording.
To protect your recording, remove these
tabs.
To
the holes with adhesive tape.
Cleaning the System
•Stains should be wiped off with a soft cloth. If the System is heavily stained, wipe it with a cloth soaked in water- diluted neutral detergent and wrung well, then wipe clean with a dry cloth.
•Since the System may deteriorate in quality, become damaged or get its paint peeled off, be careful about the following:
–DO NOT wipe it with a hard cloth.
–DO NOT wipe it forcefully.
–DO NOT wipe it with thinner or benzine.
–DO NOT apply any volatile substance such as insecticides to it.
–DO NOT allow any rubber or plastic to remain in contact for a long time.
Troubleshooting 
If you are having a problem with your System, check this list for a possible solution before calling for service.
General:
Adjustments or settings are suddenly canceled before you finish.
]There is a time limit. Repeat procedure again.
Operations are disabled.
]The
Unable to operate the System from the remote control.
]The path between the remote control and the remote sensor on the System is blocked.
]The batteries are exhausted.
No sound is heard.
]Speaker connections are incorrect or loose.
]Headphones are connected.
No picture appears on the screen.
]The video cord connections are incorrect or loose.
No picture is displayed on the TV screen, the picture is blurred, or the picture is divided into two parts.
]The System is connected to a TV which does not support progressive video input.
]Incorrect color system is selected (see page 6).
The left and right edges of the picture are missing on the screen.
]Select “4:3 LB /4:3 MULTI LB” for “MONITOR TYPE” (see page 37).
Radio Operations:
Hard to hear broadcasts because of noise.
]Antennas connections are incorrect or loose.
]The AM loop antenna is too close to the System.
]The FM antenna is not properly extended and positioned.
44