4.Connect the Sensor Wlre (15) to the wire on the Monitor
(1). Insert any excess wire into the Frame (6). Attach the Monitor to the Frame with a #8 x 112" Screw (16), Make
sure not to pinch the wire between the Frame and the Monitor.
5. Apply a small amount of grease to the shafts on the |
|
| 7 |
lower end of the Pedal Frame (7). Slide a Pedal (12) |
|
| |
onto the dght shaft. Make sure that the indicated plastic |
|
| |
tube is facing the Pedal Frame. Using the included pedal |
|
| |
tool, tap a 1/2" Push Nut (30) onto the shaft. Make sure |
|
| |
that the Push Nut Is turned so the teeth bend away |
|
| |
from the Pedal (see the Inset drawing). |
|
| |
Attach the other Pedal (not shown) in the same manner. |
|
|
|
Note: Extra 1/2" Push Nuts (30) may have been |
|
|
|
included. Save the Push Nuts and the pedal tool in case |
|
|
|
replacement Push Nuts are needed in the future. |
|
| Pedal |
|
| r | ToM |
|
|
| |
6. Remove the two 1/4" x 2" Screws (17) attaching the Seat | 6 |
| Narrow End |
(3) to the underside of the Seat Tube (5). Attach the |
| ||
|
|
|
Seat, with the narrow end forward, to the top of the Seat
Tube with the two Screws as shown.
7.Pivot the Pedal Frame (7) until the Magnet (27) Is aligned with the Reed Switch (15) (see the inset drawing). Loosen the #8 x 3/4" Screw (33). Turn the Reed Switch to the angle shown, and adjust it until there is a 1/8" gap between the Reed Switch and the Magnet. Tighten the #8 x 3/4" Screw.
5