App,y

1.Tap a :1/2" Bushing (25) into each'ride of the Frame (6) shown.

Apply grease to the Pivot Rod (21). Align the holes in the Pedal Frame (7) with the indicated tube on the

Frame (6). Tap the Pivot Rod through the Pedal Frame and the Frame.

IMPORTANT NOTE: Before assembling the 1/2" Dome Caps (29), make sure that you thoroughly understand the assembly step(s) they are used In. They can be assembled only once. If they must be removed, you wnl need to order new Dome Caps.

Center the Pivot Rod (21) and tap a 1/2" Dome Cap (29) onto each end of it.

Make sure that the Magnet (27) Is on the Pedal Frame

(7).

2.Make sure that there is a 1/2" Link Arm Bushing (19) in the dght Link Arm (4) (see the inset drawing). Slide the Link Arm onto the indicated pin on the Pedal Frame

(7).Pivot the Pedal Frame and tap a 1/2" Dome Cap

(29)onto the pin.

Attach the left Link Arm (not shown) in the same manner.

3. Slide a I 1/4" x 1" Endcap (13) onto each end of the

Handlebar (2). The Endcaps must be turned so the

round ends are on top.

Slide the Handlebar (2) into the Pedal Fi'ame(7). The

Handlebar must be turned so the sides bend toward

the Seat (not shown). Align the holes In the Handlebar

with the holes in the Pedal Frame. Attach one side of

the Handlebar with two #8 x 1/2" Screws (16). Attach

the other side of the Handlebar with two #8 x 1/2"

Screws.

)

"_Pin

Slide the I	1/4" x 1" Endcaps (13) down over the Pedal
Frame (7).