000, HOW to Operate the Monitor | Sears 831.287627 specification

DESCRIPTIONOFTHEMONITOR

Note=TheCARDIOFITfeatures one of the four monitors shown below. All four monitors have exactly the same modes. The operation of the monitors is described below.

1	2		3	4
	"_	I I- I-I.:I F_II	,,,=
Mo_	owon	oN/ttL,T
r---3 F--7		r---7	000	000
		* _qO.Ofp •	000	000

The monitor offers five modes to provide you with instant exercise feedback:

•Speed--Displays your speed, in repetitions per minute.

•Time--Displays the length of time you have exercised. Note: If you stop exercising for ten seconds or longer, the time mode will pause until you resume.

•Distance--Displays the total number of repetitions you have completed, up to 999. The display will then reset to zero and continue counting. (Monitor 2 above will display up to 9,999 repetitions.)

•Calories--Displays the approximate number of Calories you have burned. Note: If the resistance is near the highest or lowest setting, the actual number of Calories you have burned will be slightly higher or lower than the number displayed.

•Scan---Displays all of the above modes, for approximately 5 seconds each, in a repeating cycle.

HOW TO OPERATE THE MONITOR

1.To turn on the power, press the on/off button or simply begin exercising on the CARDIO FIT. (If you have monitor 2 above, press the on/reset button.) When the power is turned on, the entire display will appear for two seconds. The monitor will then be ready for operation.

2.Select one of the five modes:

Scan mode--When the power is turned on, the scan mode will be

selected automatically. One mode indicator will show that the scanMode Indicators mode has been selected, and a second mode indicator will show

which mode is currently displayed. The scan mode can also be selected by repeatedly pressing the mode button. (If you have monitor 3 above, press the scan button).

Speed, time, distance or calories mode--These modes can be

selected by repeatedly pressing the mode button. The mode indicators will show which mode has been selected. The modes will be

selected in the following order:,speed, time, distance, calories.

3.To reset the display, press the on/off button twice. (If you have monitor 2 above, press the on/reset button; if you have monitor 4 above, press the clear button).

4.To tum off the power, press the on/off button. (If you have monitor 2 above, there is no on/off button. Simply wait for about four minutes for the "auto-off" feature to turn off the power.) Note: All four monitors have an "auto-o_feature. If the pedals are not moved and the monitor buttons are not pressed for four minutes, the power will turn off automatically in order to conserve the batteries.