Press Uprights must be able to pivot freely

4.Slide the Press Frame (102) through the Seat Frame (106).

Press a 2” Square Inner Cap (112) into the indicated end of the Press Frame (102). Press a 2” Square Angled Cap (126) onto the other end of the Press Frame. Make sure the Support Plate (135 [not shown]) is inside of the 2” Square Angled Cap.

5.Attach the Press Frame (102) to the Press Base (101) with four 3/8” x 3” Carriage Bolts (115) and four 3/8” Nylon Locknuts (118).

6.Press the 2” x 3” Inner Cap (136) into the end of the Press Base (101).

Lubricate two 3/8” x 3 1/4” Bolts (124). Attach the Rear and Forward Press Uprights (104, 105) to the Press Base (101) with the Bolts and two 3/8” Nylon Locknuts (118). Note: The Rear Press Upright has an extra hole halfway down the side. Do not over- tighten the Bolts; the Press Uprights must be able to pivot freely.

Press two 2” Square Inner Caps (112) into the Rear and Forward Press Uprights (104, 105).

7.Lubricate two 3/8” x 3 1/4” Bolts (124). Attach the Press Plates (108) to the Rear and Forward Press Uprights (104, 105) with the Bolts and two 3/8” Nylon Jam Nuts (122). Do not over tighten the Bolts; the

Press Uprights must be able to pivot freely.

4
	129
		106
	112
		126
		102
5
115
		115
		102
	118
	101	118
6		112
		104
		105
	101	124
		Lubricate
	118	136
7
		124
		Lubricate
	104
		108
122	108	105