NordicTrack NTSA03991 user manual Assembly Option B

Page 11

Assembly Option B

13.Loosen the 1/2” Plain Nut (68) on the bolt at the end of the High Cable (73). Detach the bolt from the top of the Weight Tube (36) and the 5 7/8” Long Bushing

Remove the 1 1/2” Flat Washer (40) and the 5 7/8” Long Bushing (76). Put them where you can easily find them later.

14.Locate the Pulley Bracket (91) on your weight sys- tem. Detach the Pulley Bracket from the Top Frame

(1)and discard the 1/4” x 3 3/4” Bolt (92). Save the 1/4” Flat Washer (71) and the 1/4” Nylon Locknut (25).

Remove the 4” Pulley (35), the Cable Trap (44), the 3/8” x 1 3/4” Bolt (60), and the 3/8” Nylon Jamnut (63) from the Pulley Bracket. Put them where you can easily find them later.

Note: This step will leave a loop of the High Cable

(73) hanging from the Top Frame (1). This is required for the next step.

15.Turn the Pulley Bracket (91) over and attach the end of the Cable (133) to the Pulley Bracket with the 1/4” Washer (71) and the 1/4” Nylon Locknut (25) removed in step 14.

Wrap the loop of High Cable (73) around the 4” Pulley (35) that was removed in step 14. Attach the Pulley and the Cable Trap (44) to the top hole in the Pulley Bracket (91) with the 3/8” x 1 3/4” Bolt (60) and the 3/8” Nylon Jamnut (63) removed in step 14.

16.Replace the 1 1/2” Flat Washer (40) on top of the Weight Tube (36).

Tighten the bolt at the end of the High Cable (73) into the threaded hole in the Weight Tube (36).

When all Cables (73, 72 [not shown], 133 [not shown]) are tight, tighten the 1/2” Plain Nut (68) against the 1 1/2” Flat Washer (40).

Go to the Seat And Plate Assembly section on page 12 and continue with step 18.

13

 

 

73

 

 

68

 

 

40

 

 

76

 

 

 

 

36

14

 

 

92

 

 

1

 

 

 

 

73

71

 

91

63

 

25

44

35

60

 

 

15

 

 

73

 

 

63

 

35

 

 

44

 

 

25

 

60

71

 

91

133

 

 

16

 

 

73

 

 

68

 

 

40

 

 

 

36

 

11

Image 11
Contents Model No. NTSA03991 Serial No QUESTIONS?Table of Contents Important Precautions Part Identification Chart Make Assembly Easier for Yourself AssemblyFrame Assembly Press Uprights must be able to pivot freely Make sure the Cable is routed in the direction shown Cable AssemblyOpen the parts bag labeled Cable Assembly Jam Nut the Cable must be able to pivot easilyAssembly Option a Page Assembly Option B Open the parts bag labeled Seat Assembly Seat and Plate AssemblyMuscles affected quadriceps, gastrocnemius AdjustmentUsing the Leg Press Accessory Adjusting the SeatPart List-Model No. NTSA03991 Weight Resistance ChartNTSA03991 Limited Warranty Ordering Replacement Parts