NordicTrack NTBE06901 manual

10.Locate a Cable (25) and notice that there is a ball on one end of the Cable and a metal sleeve on the other end.

Route the metal-sleeve end of the Cable (25) up under the lat bar rest on the Weight Guide Frame (14), down through the indicated hole, back up through the next hole, and then down through the hole between the Weight Guides (9) as shown.

11.Insert the end of the Cable (25) into the hole in the center of the Weight Carriage (15). Attach the Cable using an M10 x 66mm Bolt (35), two M10 Flat Washers (37), two 24mm Spacers (38), and an M10 Nylon Locknut (29).

12Lift the Cable (25) in the location shown. Attach two Pulleys (24) inside the bracket on the Weight Guide Frame (14) using two M10 x 50mm Bolts (43) and two M10 Nylon Locknuts (29).

13.Lift the Cable (25) in the location shown. Attach two Pulleys (24) inside the Weight Guide Frame (14) using two M10 x 75mm Bolts (34), four M10 Flat Washers (37), four 18mm Spacers (41), and two M10 Nylon Locknuts (29).

10			14
Lat Bar			9
Rest
25
11
	37	38	25
	29
			38
			37
	15		35
12	24
			25
	29		14
			43
13	24
37			25
	41		14
29
37			41
			37
41			34
	41
	37

9